(800) 853-2651
SHOP NOW

Recent content by Ken Tallman

Yesterday's Tractor Forums
  1. K

    How many on here have never ridden on a Motorcycle ??

    I rode to Alaska in 1977. The Alcan was 1200 miles of dirt. It was a fun experience. Still have a full dress Harley, but it sets in my garage as I don't feel safe with all those bozo's with their cell phones stuck to their ear. I got ran off the rode in while I was in my car and it made me gun...
  2. K

    How do you get a water pump off a Ford 1100?

    I have a 1300 Ford. The water pump was held on with 2 or 3 bolts (can"t remember for sure). I think it is the same as yours. I do believe there was an o ring on it. I know that it was hard to get out. I used a hammer and a piece of brass to get it lose. Then I used a very thin flat blade...
  3. K

    Another landmark gone - Destroyed, say ARSON

    We had one set afire several years back. (Gudgeonville Bridge) They caught the people responsible. The punishment was not enough for what they did. Should have to make them pay restitudion or sit in jail until the dept is paid. Young men with nothing to do. Says a lot about our society today. Ken
  4. K

    Okay Pennsylvania Folks

    Near Girard
  5. K

    OT had to share this

    I traveled the Alcan Highway to Alaska in the summer of 1977 on a motorcycle with 2 other friends. The road was about 90 percent gravel then. It was one tough ride.
  6. K

    Ford 1300

    I have a Ford 1300 2 wheel drive that I have had for about ten tears. I use it to mow my 4 acres of yard and use a 60 inch Allied tph rear mount snowblower to remove snow in the winter. My land is flat and I live in the snowbelt and get a lot of snow. Its a nice tractor for it's size. It"s a bit...
  7. K

    OT S10 Pickup

    Harbor Freight has the tool for replacing that spring. It"s about 4 bucks and makes easy work of it. Auto parts stores may rent you the tool as well. Ken
  8. K

    1980 Ford 1300 Series 2-wheel Dr.

    I have a Ford 1300 and it"s been a good little tractor. I live in northwestern PA and get a lot of lake effect snow. I have a 60inch Allied snowblower that I use to clear a 350 feet driveway and a good size turnaround plus keeping the neighbors cleaned out. I also have the Model 915 belly mower...
  9. K

    o/t 93 chevy s10 heater core

    It comes out from under the dash. I had a 92 Blazer that I did one in. You have to loosen the dash so you can slide it back a little ways to get the heater core out. Not the easiest place to work in. Take your time and don't lose your patience. It took me about 5 to 6 hour to do mine. Good...
  10. K

    Made my first try at carpentry... Made a small cat house.

    Nice job on the cathouse. Just remember that we all make misstakes doing projects, but that is part of the learning curve. Keep up the good work and you will improve more and more. You justed jumped in and got your feet wet. Thats how some people learn. Remember sitting around don't teach you...
  11. K

    Ford 1500

    Try this site. external_link It should give you some infomation. I have a Ford 1300 and I got a lot of my infomation from that site. There are a lot of those tractors out there. Ken
  12. K

    tractor show

    The dates for the Porterville show are July 30th to August 2nd 2009 Ken
  13. K

    Ford 1300 Water pump removal

    I had to change mine a couple years ago. It was a bear to get loose. I hammered on it and finaly it came loose. I think tapped a screw driver in between the engine block and the pump housing and it started to come apart. If I remember right there was an O-ring on the end that goes into the...
  14. K

    retractable ratchet strap

    Google Erickson retractabje straps and you will find al kinds of places that sell them. Ken
  15. K

    Battery installation for a ford 1300 tractor

    I have a 1300 Ford and it is definitly negitive ground. Ken
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top