(800) 853-2651
SHOP NOW

Recent content by Kevin Roberts

Yesterday's Tractor Forums
  1. K

    1070 case rockshaft housing cracked

    Probably good advice. I think I?ll take heed and leave this one for the next guy.
  2. K

    1070 case rockshaft housing cracked

    what causes the lift spool not to cancel? how can you check it?
  3. K

    1070 case rockshaft housing cracked

    What would cause the rockshaft housing on a case 1070 to crack? It does have a loader and a cab, but I don't think that would put pressure up there.
  4. K

    Thickness if fast hitch prongs

    Thanks. That helps a lot. I can start looking for some scraps.
  5. K

    574 gas issues

    I feel like this is really basic question, but I don't know the answer so I'm asking. Is the fuel pump gravity fed or does it pull the gas from tank? I have plenty of fuel to and thru the sediment bulb but can't seem to get fuel out of the pump. When I remove fuel line from carburator side of...
  6. K

    wide frond end applications

    I'll check it out. Thanks to everyone.
  7. K

    wide frond end applications

    How much? Probably more than the tractorss worth?
  8. K

    wide frond end applications

    It was already sold before I even posted the question. I wasn't quick enough. Anyway, I'm looking for one close to northwest missouri
  9. K

    wide frond end applications

    Will a schwartz wfe that is on a 560 fit on a 400 without modification?
  10. K

    574 gas issues

    That inlet screen was almost completely clogged. I didn't know it was there. Thanks everybody.
  11. K

    574 gas issues

    The selinoide was removed and replaced with a plug.
  12. K

    574 gas issues

    My 574 acts like it is out of gas. Sediment bulb screen is clean, seem to get plenty of gas without sediment bulb on, so I don't think rust in tank is the culprit.let it set a few minutes, hit the starter and she'll run for few seconds, then die like she's out of gas. Gas does run real slow out...
  13. K

    mw brakes

    That was what was advertized. They were supposedly M&W aftermarket brakes on an M Farmall. I now know M and 400 brakes aren't interchangeable, but would still be interested in knowing if there are better than factory brakes available for these, or if there ever were any available..just for the...
  14. K

    farmall 400 drawbar

    Now I know they are out there and you all have explained how they mount up, I can start looking for one. One more question: will the straight drawbar work with the drawbar mounted jet wire roller and drawbar mounted seeders(similar mounting on both) and is the fh drawbar longer than typical...
  15. K

    farmall 400 drawbar

    I thought I saw a picture of one on here so where, but it wasn't a good angle. I would probably need to compare one without fast hitch to one with fast hitch to figure out the mounting.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top