Recent content by KF

  1. K

    LT 133 John Deere

    The kohler engine is cv13s-21525 with the stator diode missing. This engine has both four and two legged varmints messing with the wiring. I may just use a generic diode to make it work.
  2. K

    LT 133 John Deere

    What is shown is the lt133 wiring harness. I have that harness with that diode[v1]. The stator has its own harness and diode[v2]. V2 is the one that is missing.
  3. K

    LT 133 John Deere

    I am working on a LT133 mower with a Kohler 13s engine. It has a 3amp stator. The diode going to the stator is missing. Does any one know the value/size of this diode.
  4. K

    What points are these? 1949 TE20

    Prestolite sold a replacement distributor
  5. K

    Prestolite sold a replacement distributor

    Prestolite sold a replacement distributor
  6. K

    What points are these? 1949 TE20

    Prestolite sold a replacement distributor
  7. K

    Prestolite sold a replacement distributor

    Prestolite sold a replacement distributor
  8. K

    I want make my own voltmeter leads

    The only thing I know of off hand is that a small soldering iron might be modified to do what you want.
  9. K

    Vinyl Scum

    I worked in a automotive test lab. The phenomenon is called fogging and there are limits that some manufacturers have on the extent of fogging. In one test, the film accumulation is measured by weight on a standard specimen.
  10. K

    Cub 125 - issues low power - back firing

    I have a K301. Check the obvious. Check the points and the gap. Check that the spark is strong and not weak. Check the timing at the little viewport. Check that the gas flow to the fuel pump is good. Then check the flow from the pump to the carb is a strong pumping action. Check that the...
  11. K

    K241

    If he ground your crank then you have your original crank. If your crank was bad then another may have been used. Not likely as there aren't that many old kohlers around anymore.
  12. K

    Model Series 760 starts chocking out after approx. 10 mi

    Sounds like a problem with the gas flow. If carb has a needle and float, make sure the float is at the right level and that it is not full of gas from a hole. I had one that after a few minutes would cut out. Found that when the tank got half full there was not enough pressure to fill the...
  13. K

    Is a pickup truck a tool...

    I second this problem as a possible cause as it happened to my 92 chevy truck. It will make the engine flood out and not start. However, my check engine light came on with the code for the temperature sensor.
  14. K

    3-ton floor jack recommendation

    Most of the Chinese floor jacks are made by Shin Fu. I repaired a 3 ton jack a couple years ago. The repair kits are available. I started with the model and name of the jack. It will end up at a Shin Fu repair kit.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top