(800) 853-2651
SHOP NOW

Recent content by Kory1998

Yesterday's Tractor Forums
  1. K

    Farmall 806 diesel Roosa master fuel pressure check

    How and where does one check the fuel pressure on the Rosa master pump for a 806 need to see what delivery pressure is ! I’m assuming it’s the plug under the 90 degree angle for incoming fuel,
  2. K

    Farmall 806 diesel

    So I figured out what was wrong Smoke screw was back Danm near all the way out, and low idle screw was too, got to run pretty smooth now, I also timed to 6 degrees idk if it makes a difference being it has a 3dh Rosa master that says to time to 8 degrees .
  3. K

    Farmall 806 diesel

    Bought me a nice looking farmall 806 diesel it has the Rosa master pump on it later serial number, tractor has a hard time to start I re did all the electrical connections and put new battery big 12 volt in it , but when it starts it sounds like it knocks on start up like how those old d282...
  4. K

    New Holland 326

    Been bailing with 326 new Holland square baler, with my 806 diesel. For some reason the 806 surges really bad to where I kind of get worried about tearing drive line up in tractor. I unloosen all springs and slipped the clutches to where they were hot. What else could be the issue or what else...
  5. K

    MW rc456 10 wheel rake

    Was wanting to know who manufactures parts for these things , and find some history on them?
  6. K

    Mw wheel rake parts

    Model is M&w rc456 10 wheel rake Need to find some replacement metal pipe tubes for wheels, where and who makes them?
  7. K

    Mw wheel rake parts

    I am looking for some replacement tube pieces for my m&w 10 wheel hay rake What brands are close to this model I know m&w got sold out or bought out, can anyone help me out I recall for months back their was a site that sold frame tube pieces for the rakes or similar models for them.
  8. K

    Farmall 504 engine swap

    Can you put a d188 Diesel engine from a 504 diesel in a 504 gas tractor that had a c153
  9. K

    4020 engine oil pressure

    Diesel
  10. K

    4020 engine oil pressure

    Have a 1965 4020 At cold start it has roughly 60-65 oil pressure gauge wise. And if reved it goes almost up to 80 psi. But once warm up it starts to come down at around 40-45 psi at low idle when at operating temp its about 15-20 psi. Is their anything wrong with those readings?
  11. K

    Quad range vs powershift

    I want someone or opinions when it comes to servicing and are working on these transmission which one is easier to service and troubleshoot. I know powershift is more user friendly but Im asking about the service factor side of working on them.
  12. K

    1086 hydraulic remote keeps popping hoses out

    Went and ran shredder on 1086 and it has dual remotes, one remote holds hood, the other keeps spitting one hose out, have swapped hoses to see if it was fittings and it didnt help. I have pioneer ends on shredder. Is the coupler the problem?
  13. K

    1086 update

    After changing oil and filter which was plugged behind solid, tractor is still doing same stuff, I notice where people are talking about this supercharge line, I have a open center hydraulic system and that line is still their, I can also hear a faint whine at mcv pump which it sounds like it...
  14. K

    1086 hydraulic update

    Update I pulled filter and drained oil , it was plug majorly and oil had black gunk like dirt build up. My question is where the filter goes their is a tin metal plate that looks like it has an oil ring behind it should I try and pull that out and replace seal since Im already this far into...
  15. K

    International 1086 hitch pump replacement

    Tractor has 8200 hrs on tach Drive it down road and ran it up to operating temp, seems to work a little better on hydraulics. I have bought filter and 30 gallons of oil will drain and flush oil
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top