(800) 853-2651
SHOP NOW

Recent content by kotchb

Yesterday's Tractor Forums
  1. K

    Magneto vs distributor

    Id like to try here so i may ask you a few questions along the way. Much appreciated. Bob
  2. K

    Magneto vs distributor

    Right now quick test w plug and wire doesnt spark
  3. K

    Magneto vs distributor

    Ill install magneto after i get it to spark. I set engine to TDC#1and pulled distributor n bracket from the governor. The gear drive notches are parallel to the ground. When i set the magneto to fire at #1 position can i pull gear out and reset it to match the magneto drive. Its at a 45°...
  4. K

    Magneto vs distributor

    Ill just plug #1 into spot labeled #4 and continue frim there. Photos of B tractors show this. My cap will just have wrong stampd numbers. May replace it someday w correct cap
  5. K

    Magneto vs distributor

  6. K

    Magneto vs distributor

    The mag is correct model. Stamped on side. Cap could be replaced.
  7. K

    Magneto vs distributor

    Interesting that magneto cap has #1 at upper right and progresses around cap. Number 4 is closest to block. I thought #1 would be closest to #1 plug
  8. K

    Magneto vs distributor

    And im thinkin i can go back to two posit switch in place of resistor switch i just put in. It has no lights.
  9. K

    Magneto vs distributor

    Got mag in the mail today. Been lookn over schematic for it and appears that there are no wires to attach if i use kill tab. Understand the convenience of kill switch on column but this tractor has been a real battle so any chance to elim sumpn im all in
  10. K

    Magneto vs distributor

    Just watched a quick video about installation. Its as i assumed; start at TDC.
  11. K

    Magneto vs distributor

    I will be installing. Top right i assume
  12. K

    Magneto vs distributor

    And #1 is where tradtionally on a mag?
  13. K

    Magneto vs distributor

    Ive seen videos about how to grip the handle. Magneto arrives Friday. Timing it..TDC #1 cyl. Remove dist. Install mag w rotor or whatever pointing to #1 wire?
  14. K

    Z4b4b fm magneto

    Still lookn for correct model. I did steal the condenser from it for the distributor.
  15. K

    Magneto vs distributor

    Ill use this pic for my resto. Did it have a choke rod? Mine does not and when i had carb rebuilt it did not come back with any linkage.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top