(800) 853-2651
SHOP NOW

Recent content by L.Fure

Yesterday's Tractor Forums
  1. L

    Leaky Hydraulic Couplers.

    Thanks for the quick reply Tgrasher. I'll look into rebuilding them. Are they hard to dismantle?
  2. L

    Leaky Hydraulic Couplers.

    I'm sure this has been discussed in the past, but I don't remember the outcome. I have leaky hydraulic couplers on my 600B. They leak while there is nothing hooked up to them. Is there any way to stop this without replacing the coupler?
  3. L

    Road trip picts

    I think you are looking at the wagon hitch. Wagons were pulled along beside the picker, not behind the machine like newer models are.
  4. L

    Enlighten me

    2000rpm.
  5. L

    400 b Hydraulic levers under battery

    The roll pins can be replaced without removing the gas tank. I replaced these pins in a 300RN, 530, and 600B without removing a bunch of stuff first. I used short pieces of rod that are a little smaller in diameter than the roll pin, and some small pry bars. Pry a short rod in the hole to get...
  6. L

    Case611b GoPro

    Add a 90-degree elbow on the top and point it forward. See if that helps.
  7. L

    Case611b GoPro

    You have it running really well. Is that muffler for an Allis Chalmers D17? It really quiets the engine noise.
  8. L

    Case 530 lubrication questions

    The steering rod seal is shot in my 530's steering gear box. Since the tractor doesn't get used very often, I drained out the 80-90 that was in it, and added a zerk in the drain plug. I then filled it full of JD corn head grease. If you still want to fill it with 80-90, the manual states to fill...
  9. L

    Case 646 hydraulic oil

    Yes, it does use motor oil in the hydraulics. Fill the reservoir 5" to 6" from the top of the reservoir fill hole. 15-40 Rotella will work for summer and winter.
  10. L

    The 611B Lives!

    Sounds pretty good.
  11. L

    Started as a simple oil change.....

    You better find out why the piston skirt had broken in the first place. The skirt might break on the new piston the first time you run it. I had a 2.3L Ford engine that had a knock in the engine. Turned out that the skirt was broken, so I replace the one piston with a new one, without figuring...
  12. L

    Case 530 3 point and brake help

    https://forums.yesterdaystractors.com/viewtopic.php?t=1303172&highlight=
  13. L

    Eagle Hitch Lever Fabrication

    Looks pretty good.
  14. L

    600b Update

    Ben, Do you have contact information for the person that makers the aluminum gauge plate? I'd like to put gauges on my 600B.
  15. L

    Draining the 600B.

    I don't think the case-o-matic really caught on for most farmers. They would rather have a 500B than the slipping case-o-matic. At least that's what I hear from the older farmers when the subject comes up.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top