-
L
3600 Muffler / Exhaust Options
Pretty sure this is the case. The mod is well done except for the fume factor. I'm going to cut off the 90 and ad an extension that will fit in my shed door as option 1. If I still have issues, I'll look at going horizontal. -
L
3600 Muffler / Exhaust Options
Thanks for the replies. I'll do some homework and make a decision. -
L
3600 Muffler / Exhaust Options
I use a 3600 for Brush Hog / mowing work. I'll be converting 18 acres from pollinator habitat to pasture the next few years which will require frequent mowing( many hours of seat time ). Current set up is an upright muffler running up outside the hood which 90 degrees out approx 6" above my... -
L
Ford 3600 - Tubes?
Closing out this thread. Thanks for the insights gents. Looks like I got away with a core replacement. 24 hrs later and still holding where I left it. -
L
Ford 3600 - Tubes?
Thank you. I did replace the core with a " Slime " brand valve. The plastic nut has deteriorated. The soapy water test had a leak at the base of the stem when I started to fill it up with little pressure. I could not find a leak once I got 10 lbs or so in it? I guess time will tell if it... -
L
Ford 3600 - Tubes?
Here’s a picture with the core removed. The fuzzy picture in the first post is from the other rear. -
L
Ford 3600 - Tubes?
Think I have tubes on the rear on my 1981 3600? I have a leaky valve. I replaced the core today and it stopped by I'm guessing this may not be the last of it. -
L
Ford 5000 cranks but doesnt start
Just went through this on my diesel. See the thread below. I might be your problem if you have fuel to the pump but not the lines. https://forums.yesterdaystractors.com/threads/3600-fuel.1793254/ -
L
3600 Fuel?
Just closing out this thread. I worked both the shut off lever and the throttle lever vigorously while cranking the engine. One of these freed up the metering valve ( I suspect it was the shut off lever ). I added some 2 stroke oil and mowed a couple of acres. I hope this is behind me. From... -
L
3600 Fuel?
3 cylinder diesel. Tried to start it for the first time since December. Hit nice for about 1 second and died. Fuel squirts at the pump. Fuel seeps out ( not squirting out )at the line screws. Won’t start again. Thoughts? Should I have more pressure there? It ran well when I put it to... -
L
Fuel Filter wont fill?
Took the o-ring out, everything is good!! Whew, dodged a bullet on this one. -
L
Fuel Filter wont fill?
I have that one in currently. Thank you, thank you, thank you!! I would have been tearing apart my tractor trying to figure this out. -
L
Fuel Filter wont fill?
It is a Napa Filter and I used all of the o-rings. So, there are two equal sized rings in the kit. One fits on the top and one on the bottom of the filter. I need to remove the one on the top? -
L
Fuel Filter wont fill?
I pretty sure it doesn't. I've done the change out before and have not messed with a lift pump. Thanks for the idea. How long would one think it may take? I waited 10 -15 minutes before giving up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy