(800) 853-2651
SHOP NOW

Recent content by larwe-8

Yesterday's Tractor Forums
  1. L

    350 wide front IH engine swap to 1941 H

    Got both covers removed and the holes drilled in H cover. Now a lot of cleaning and waiting on gaskets. Thanks everyone!
  2. L

    350 wide front IH engine swap to 1941 H

    The 1/2" bolts I referred to hold the front 350 cover on to block. The H uses 3/8" bolts to secure the front cover to block.
  3. L

    350 wide front IH engine swap to 1941 H

    Yes the 350 was a short utility tractor. The 1/2" bolts I referred to hold the front cover on to block. Thanks for any information.
  4. L

    350 wide front IH engine swap to 1941 H

    Got engine from 350 to go in H. The engine had been in fire and hoses and wires burned. Want to change front cover and use H cover. The 350 cover is too wide to fit in frame rails. Haven't taken apart yet but noticed 350 used 1/2 -13 bolts and H using 3/8 bolts. Are there 1/2 by 3/8 studs...
  5. L

    HD7W Steering clutch removal

    Have removed all parts as you said and have a slide hammer on clutch shaft. it will move in and out about two inches and then won't go any further out. May have to take apart final drive to get out.
  6. L

    HD7W Steering clutch removal

    Thanks for the info I still haven't got apart. Larry
  7. L

    HD7W Steering clutch removal

    Read somewhere you could pull shaft all the way out and pull both steering clutches. Is this not a good idea. Is it better to pull both pinions and move it back and forth to pull clutch pack on each side and not take shaft all the way out. thanks Lee for the responses. Larry
  8. L

    HD7W Steering clutch removal

    Have pulled right pinion. I can get movement of clutch shaft but not far, then it feels solid. Is the clutch shaft interference fit with bearings on the way out?
  9. L

    HD7W Steering clutch removal

    Have 1947 Allis and steering clutch removal in progress. Have right pinion removed. Have spacers removed from each end of steering clutch. Can get movement in and out a short distance. IS steering shaft a slight bit smaller than pinion or is it the same diameter? Anyone have steering discs for...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top