(800) 853-2651
SHOP NOW

Recent content by LiL Steve

Yesterday's Tractor Forums
  1. kcm.MN

    2023.09.19 Tractor Pic

    Allis-Chalmers D-10 tractors Puzzle: https://jigex.com/q8jvj
  2. M

    Ford Tractor Model Unknown

    Hey I have a Ford tractor that I am wanting to order new hydraulic pump for. I m not sure the model. It s yellow (construction model maybe?) thanks for any input!
  3. D

    Super H Stage I conversion to stage II?

    Im attempting to figure out when exactly the Farmall Super H changed from stage I to stage II. I know that the stage I line of Super Hs changed to stage II sometime in late 53 but would like to know when (month/day?) and possibly the first serial number of this change. If anyone has any...
  4. 3

    JD 401 B industrial

    The starter needs to be rebuilt on my tractor. I can get a new china starter for 210.00 shipped to me in 3 days, take it out of the box, and have it on and ready to go, or have my original rebuilt, unknown cost. Anyone had a starter rebuilr recently? What did it cost? Thanks stan
  5. B

    John Deere 350b steering clutch shaft.

    Well guys Ive taken the drive back off again well multiple times. The housing isnt meshing together on the frame the way it should. As well as I ruined one pilot bearing. I ordered another. But the steering input shaft on all the manuals says it should just come out with the pressure plate...
  6. B

    8n side mount question

    trying to tune engine with vacuum gauge, needle stays at 18 for a few instants and then fluctuates slightly (1 or 2 ) then back to steady over and over no matter what carb setting , 3 cylinders have 105 comp and the third has 110, valve gaps checked and rechecked , oil...
  7. G

    pressure washer??

    I bought this Worx pressure washer last august, washed my little deck and some siding and parked it in the basement. Saturday I got it out to wash my garden tractor. Worked perfect for about a half hour and then a brass fitting popped off the bottom, looked like it had been over tightened. I got...
  8. A

    starter

    looking for used good starter IH 450 gas 12 vol,
  9. 8

    Old Makita battery drill

    What do you do with a 20 year old battery powered Makita drill kit with charger and battery in the original as the battery is not recharging anymore ??
  10. G

    differences between b275 and 414

    Hi, I have an '62 b275. I might have the possibility to get a 414 for the parts, are there enough common parts between both to make it worth it?
  11. A

    Small crack in block model C between #2 and #3 sleeve

    Just how common is it on these blocks? I recall many years ago having a discussion about this issue. Seems it is a very common trait of this engine. My memory tells me that Dick L thought it wasn t much of an issue. Just remove freeze plug and drill and tap for 1/2" - 13 bolt.
  12. S

    Slightly overloaded truck

    From CDL life. A story about an overloaded truck and no oversize permits. Look at the citation at the bottom for overload weight. Oooopps. Needed a stealth truck. Overloaded truck. 4340 dollars owed
  13. T

    Testing a temp sensor?

    I am working on a Super C Farmall and had to replace the bad water pump. The water temp gauge was busted. I got a new gauge assembly and it did not read anything. The tractor was full of water and I worked it hard on a burkley water pump for a couple hours. Still no reading, needle stayed at...
  14. O

    IH584 loss of steering

    I ran it a bit low on hyd fluid and then added 5 gals and things worked fine for a few minutes. I figured I best add some fuel so drove it closer to where I had the fuel. Then it lost steering so I shut it down due to that and a hyd fluid leak down around the bottom of the steering column so now...
  15. R

    corn picking questions

    I'm getting ready to pick some tall heirloom corn (Jimmy Red). In the past I have used my H but the 350 has live PTO which is a nice feature. The H would run in 2nd and do a good job with matching the ground speed to the gathering chains. The 350 seems a little faster, so 1) Is the speed close...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top