(800) 853-2651
SHOP NOW

Recent content by Lurch

Yesterday's Tractor Forums
  1. L

    John Deere 310 A Throttle Linkage / Speed Control Linkage Stuck, frozen rusted fast how to remove replace.

    Hello All, The throttle Speed Control Linkage is rusted fast and stuck. The machine has been sitting for at least 2 years. After days of trying to remove the gas pedal and roll pin in the linkage on the passenger side, I finally got the cross-Over linkage shaft barely moving enough to bang it...
  2. L

    John Deere 310 A steering wheel removal

    Thanks Jim, and as I was just out walking, it occurred to me that, that was what it was for. Doh! :whistle::whistle: Apparently, long ago i bought a puller for that purpose and completely forgot. Thanks for verifying and pictures are great. I am going to make a separate post as to Why I...
  3. L

    John Deere 310 A steering wheel removal

    Hello All, Does anyone have any pics from removing a steering wheel from a JD 310 A. I have removed the emblem and the large flat nut, with star shape washer. Underneath, looks like a round flat plate about 1/4" thick. It looks like it is either threaded on or pressed on the center shaft. The...
  4. L

    John Deere 310A Cavitating and Bucket/Hoe raise part way

    As it turned out, I went back out later, ran the booms up and down slowly for a while and it stopped most of the cavitating and then all worked fine.
  5. L

    John Deere 310A Cavitating and Bucket/Hoe raise part way

    Hello All, It's been a while since I have been here. Anyway my 310A gets used about 1-2 year. This time I check the Hyd Oil and looks frothy when I used it a couple weeks ago and was cavitating but usable. I put about 2 gals of oil in and it looks way over full but frothy. When I ran it...
  6. L

    Mounted bagger on top of pull-behind mower Deck

    Does anyone know if a 3-pt type bagger can be mounted on top of a pull-behind, side discharge mower deck, using the same 3-pt as the bagger?
  7. L

    Mulching mower decks

    Thanks Warren. That's what i need to Know.
  8. L

    Mulching mower decks

    Has anyone had any experience using a PTO Finish&mulching mower deck, in high grass, 1ft or s? My question is, will they still mulch when the gras is that high?
  9. L

    9N/8N Starting problems continued

    All I had to do was remove the pressure relief valve screw, squirt about a cup of oil in and started the engine. Oil pressure is up to 25 or so.
  10. L

    9N/8N Starting problems continued

    It's a 9N tractor with an 8N engine, but has front mount and gen cut-out. No other Vregulator though.
  11. L

    9N/8N Starting problems continued

    Just installed the AL437 spark plugs and it started up immediately and continued running well. But i soon had to turn it off because it now has "0" oil pressure. Cracked the line at the base of the oil pressure guage and nothing comes out. I may make a separate post about that after searching...
  12. L

    electrolisis tank

    What is this being discussed here?
  13. L

    9N/8N Starting problems continued

    Forgot to mention ammeter reading is with ignition switch on, off and / or battery disconnected.
  14. L

    9N/8N Starting problems continued

    The ammeter was centered when i bought it, although others on the shelf were not. But just handling it, i noticed the needle wasn't quite centered. So just took a closer look and it looks like it is about + 1 amp or one needle width to the right of center and disconnecting battery doesn't...
  15. L

    9N/8N Starting problems continued

    Also forgot to mention that i took the plugs out, heated them with a small propane torch to dry them out, re-installed, but engine still only sputtered a little and no starting.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top