Recent content by Luxpatriate

  1. L

    Super 55 PTO does not engage

    Thanks for the insight.
  2. L

    Super 55 PTO does not engage

    Kent, Good news. I have retrieved my tractor from the farm, ready to start the Z Split. Will download the I&T manual today as well. Can you confirm that this is the correct seal kit and that replacing the seals once the split is done is a bench job that does not require any special...
  3. L

    Super 55 PTO does not engage

    So if I am splitting the tractor...do I go ahead and replace the drive clutch too? I have not noticed an issue with it, but splitting a tractor scares me (perhaps unnecessarily).
  4. L

    Super 55 PTO does not engage

    Yes. I depressed the pin and turned the crown nut clockwise and counterclockwise and tested at various settings. Never does my engagement lever (from the cockpit) ever become necessary for 30lbs to move the lever. Perhaps some fiber plates are gone. Clutch pack rebuild likely required and based...
  5. L

    Super 55 PTO does not engage

    Yeah, I have seen this video and another, but it wasnt helpful. I adjusted the clutch in the very direction up to just before that crown nut wants to come off. I never reached a spot where it takes any effort (mush less 30lbs) to engage the clutch. Perhaps I have missing parts or destroyed fiber...
  6. L

    Super 55 PTO does not engage

    I bought my first tractor. A fairly sorted out early Super 55. The first attempt to shred brought to my attention that the PTO is not right. I adjusted it many ways, but nothing worked. I notice that it is very easy to move the PTO lever. I think it is supposed to have some amount of pressure...
  7. L

    Z129 Rebuild

    I think I am going se d it to Iowa. Midwest Cylinder Head. They can do the furnace braze block repair I read about on this forum. I am curious if anyone has ever done the tension rod repair in combination with the brazing. Seems like that would make it stronger.
  8. L

    Z129 Rebuild

    Texas man here. Not a foreigner at all. But I did live abroad for a couple years as an adult.
  9. L

    Z129 Rebuild

    Block is cracked in 3 places between each cylinder...so to the grave yard this tractor goes....
  10. L

    Z129 Rebuild

    I am in the DFW area as well. I will look for an engine shop today. Your insight is very helpful and straight to the point. Thanks so much.
  11. L

    Z129 Rebuild

    Thanks! The old man that gave it to me said I was mowing...and turned into some high grass...it started bucking and lugging and died. I could not get it started again. 15 years later, I have it, was trying to run a compression test and the radiator front cylinder would not turn over under...
  12. L

    Z129 Rebuild

    So a guy gave me an at least slightly busted TO-30. I have pulled the head...not too worried about cash, but this is my first rebuild. I am thinking all the labor to get where I am...might as well rebuild the engine. Planning to call local shops that can do the mill work and install sleeves...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top