(800) 853-2651
SHOP NOW

Recent content by Lydia

Yesterday's Tractor Forums
  1. 5

    MM U backfires

    What is the most likely cause of an MM U backfiring? Thanks for your help.
  2. H

    550 carburetor application

    I wonder if someone could give me some insight on the carburetor I am about to try a rebuild for my Oliver 55o. The carb shows as a Zenith 14644, but my parts manual only shows a Zenith 12427 as the original option for that model. I did find one application for the 14644 on an Oliver 880 and...
  3. W

    WWII 2N on FBM

    Still has the magneto and starter button block-off. 1943 2N
  4. D

    Paint

    Where to get clove white paint for wheels on a oliver
  5. kcm.MN

    2021.12.15 Rust Pic

    Massey Harris 20 Puzzle: https://jigex.com/PRUC3
  6. F

    Re: CAT D7E - Hydraulic reservoir

    Good day everyone. I have search the archives with no luck. I have two CAT D7E dozers, on with tilt blade. The one without tilt blade (Serial 48A5029). Unfortunately have only repair/part manual for one with tilt blade. Looking for part extraction on Hydraulic reservoir so that I can check on...
  7. I

    old buildings

    My wife and I are in the process of buying her family's 140+ year old farm or at least all the buildings and 4.5 acres. unfortunately her grandparents didn't really do much for upkeep over the past 10-15 years. there is an old grainery that is basically built like a small barn (about 16x20 in...
  8. B

    Case 1030- charging system repost.

    Well I thought I had this tractor fixed; I replaced the regulator as the new one on it evidently had points stuck on the regulator and draining my battery's over a few days; still doin it! New batteries, new genny and regulator; what the heck can drain my batteries on a diesel tractor with the...
  9. J

    Loegering tracks for skid steer

    I have a LS170 new Holland skid steer and I picked up a set of used loegering steel tracks that came off a case 1840 I think. I installed wheel spacers and lengthened the tracks but they still Seem to short. I dont have the installation tool but with straps it seems like I wont be able to get...
  10. JohnRowehl

    Keystone Oliver Collector Assoc. of PA

    Held their plow day this past Saturday. Dreary weather overhead but good soil conditions below. And I got to have a ride for a round on an Amish plow. Hoping to be a participant with one of my 77s someday.
  11. C

    Farmall 806 Diesel - odd rear wheel issue

    Hi All!! Been a while since on the board - fall time is hectic, as I am sure y'all know. Anywho - it is that time of year to put away the tractors for the winter and after going through my normal winterize routine, I had an odd issue with the Farmall 806D. I will do my best to explain. So I...
  12. S

    Staw is sold

    Sold it for 35$ a ton and they will come get it bales are 300 pounds .
  13. L

    SUPER 55 PTO CLUTCH PLATES

    HI GUY'S READY TO PUT MY TRACTOR BACK TO GETHER, THOSE 5 FIBER CLUTCH PLATES FOR THE PTO CAN'T GET THEM TO FIT IN THE DRUM. TRIED ABOUT EVERY THING YES EVERY THING IS NEW FIBER TOOTH PLATES & METAL PLATES --- TRIED THEM TIGHT, TRIED THEM LOOSE DOSEN'T SAY HOW TO PUT IT BACK ITT MANUAL TRIED TO...
  14. L

    Ford tractor model number

    Need model number for Ford tractor numbers on flat behind starter are 41300D under that is 28888
  15. B

    Oliver 1550 w/Holley Dist-bad vacuum advance

    Hey all, new here.... I'm sure it's kicking a dead horse, but as stated in the subject, I've got a 1965 Oliver 1550 with the Holley distributor and I noticed last year that she was bogging when I'd accelerate. Initially (as most do) I headed to the carb, which ran good both at idle and full...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top