(800) 853-2651
SHOP NOW

Recent content by macec3(TX)

Yesterday's Tractor Forums
  1. M

    Parasite killer for dogs

    Interceptor for our border collie.
  2. M

    OK, I want to know

    I have a 570 New Holland square baler. It is washed thoroughly from top to bottom. Every blade of grass and every grass seed is washed out of the baler. Set the baler out in the hot sun to dry with all the doors open. When everything is dry, I grease all the fittings and put it back under the...
  3. M

    Bale loader

    I have one similar to that. Wife drives the tractor and I stack on the trailer. It takes a lot of work out of hay hauling. IMO it is worth its weight in gold.
  4. M

    5610 II starter.

    Been having trouble with the starter on my 5610 II. Nothing when I turned the key. Took starter and solenoid to starter/alternator shop for a check. Owner said it was working fine. Told him what that tractor was doing and he said check the neutral safety switch. Bypassed the NSW and the tractor...
  5. M

    5610 or 6600??

    1990 - 5610 is what I came up with. I think the 6600 has a turbo, 5610 no turbo. I know my 2 5610s do not have turbo. The 6600 Ford serial numbers begin with C_ _ _ _ _ _. http://www.tractordata.com/farm-tractors is the link for that type info.
  6. M

    Member Map

    Is there some way to look up a member?
  7. M

    Ford 5610 Special 2 loader

    Piston packing could be bad in the lift cylinders. This is what I would check.
  8. M

    Onan / miller update

    SV, I have a muffler for an Onan engine. It was on a 225 Miller Bobcat with a 16 HP engine. Muffler is very good. $30 + shipping. If you are interested, let me know. 903-863-2228
  9. M

    Grandpa Amu builds a bridge

    No nails, glue or power tools. Amazing.
  10. M

    Crunch,smash

    DeltaRed, glad you posted this. All this time, I thought I was the only one who did things like this. What a relief to know others do it to.
  11. M

    ford 1200 stuck clutch

    Tie the clutch pedal down with a bungee cord. Start it and go. Drive it around a while. Stuck clutch has happened to me several times. The last time, I was driving my Ford around in the hay field. Went across a shallow dip/ditch. This caused the tractor to bounce a little. That is when it popped...
  12. M

    What do you do when you're smartphone won't fit in your bib?

    I wear overalls 99% of the time. Carry my wallet in the bib pocket. Those pockets are not wide enough to easily get the wallet in and out of, but I struggle with it. Maybe I need a smaller wallet. The hammer loop is so large that a heavy Estwing framing hammer will fall thru. Seems like the...
  13. M

    Dang nammit ennaways!

    https://www.youtube.com/watch?v=t6K_fgTKn5c
  14. M

    Built to fail

    I grease mine before each use. Dixie Chopper 16/17 years old. No bearing failures so far. After the mower has been used for a while, the bearings will get louder. Grease them and they get quiet. I just believe in grease. Use a lot of it on lawnmower, tractors, and sawmill. One of my pickups has...
  15. M

    Tractor Chickens

    I usually have a few when cutting hay or mowing pastures. This week while cutting hay, none showed up. Now I know why. They are all in SE Texas. We usually have a few with the horses in the pasture.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top