-
M
Ford 4000 hydraulics
Okay, now i tested the pressure of hydraulic system while under load. It was still pushing 170bar and the nose got only slightly lighter. And the push bar that uses remote hydraulic only moved in or out about 1inch or 2cm and did nothing else This post was edited by MAJK on 06/01/2023 at 08:24 am. -
M
Ford 4000 hydraulics
When i measured it was working properly. Maybe i have to take new measurements with load on 3pt and when it stops working properly take new measurements. -
M
Ford 4000 hydraulics
Now i measured hydraulic pressure, when it was cold it was 170bar and when warm it was a bit less than 170bar. It didnt change much if i was idling or giving revs. Max 5bar was change. So i think there must be clog somewhere and i need to take the lift cover off. -
M
Ford 4000 hydraulics
The pump has been changed at some point because its not blue anymore. Or atleast i think so. Today i will measure hydraulic pressures.I also think that there might be something that clogs something on the hydraulic system. -
M
Ford 4000 hydraulics
Hello, i have a following problem with my ford 4000. The 3pt hitch is lacking power sometimes. Sometimes it has enough strenght even to lift the nose up, and sometimes it only slighty makes the nose lighter. Same time when the 3pt is lacking its lifting power the remote hydraulics stop working... -
M
Ford 4000 hydraulics
Hello, i have a following problem with my ford 4000. The 3pt hitch is lacking power sometimes. Sometimes it has enough strenght even to lift the nose up, and sometimes it only slighty makes the nose lighter. Same time when the 3pt is lacking its lifting power the remote hydraulics stop working...- MAJK
- Thread
- Replies: 0
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy