(800) 853-2651
SHOP NOW

Recent content by manya77

Yesterday's Tractor Forums
  1. M

    remote hydraulic control 9n ?

    I sent a picture of this to Zane re compatibility with his Thang. This control is just below quadrant He suggested I post pictures here, apparently quite unusual. This 9n also has the OEM cut out some found unusual
  2. M

    strategy for overheating issue ?

    I started it up to continue with the vinegar wash, ran great, so I mowed a little. An hour later is was still running great. I has not run that long without dying in a year. Wondering if I need to flush that vinegar out ( 1gallon vinegar to 2 gallons water) right away or let it work for a while...
  3. M

    fan makes squeak when turned by hand. Should it ?

    I am at overload of things I do not understand for today. Will revisit in the morning. Thanks for your patience.
  4. M

    Afraid to try to start.

    I am so relieved after the frustrations of the past year when nobody local would help me I want to start it up just to enjoy the sound. I only use it to mow the house lot of an acre as needed by rainfall, and a conservation lot of 10 acres for woody growth twice a year. All is done with a...
  5. M

    new ground cable terminal does not fit battery terminal.

    I bought it a replacement set of 3 cables for 9N/2N, 1 post generator, positive ground. The starter cable was too short and the battery ground cable does not fit. bummer.
  6. M

    fan makes squeak when turned by hand. Should it ?

    I can't tell if the noise is the fan shaft or the belt. I discovered this when working on the radiator issue I have in another thread, to try and get to top radiator hose. Fan makes no noise when running. After I hosed the fins the squeak stopped, apparently from water getting to it.
  7. M

    strategy for overheating issue ?

    I have abandoned the idea of replacing the thermostat/backflushing for now. I did refill the radiator with vinegar/water and ran for a while and cleaned the fins. Will repeat several times until I can get a thermometer ( I like my meat still moving ). I am 15 miles from anything so don't go...
  8. M

    strategy for overheating issue ?

    Local guy tells me I have to remove hood and gas tank to get at upper hose. Not possible, I have no help and am elderly. If I just cut the hose will I be able to snivel the top connection off ?
  9. M

    strategy for overheating issue ?

    to remove the thermostat I have to disconnect the top hose at both ends. Is there a trick to this ? It is pretty stiff, and the top clamp is very difficult to get to.
  10. M

    strategy for overheating issue ?

    I am not describing properly. There is no bubbling over of the radiator. Coolant level stays steady. But the engine block gets very hot very fast, within minutes.
  11. M

    strategy for overheating issue ?

    sorry I edited to show it is a 9N
  12. M

    strategy for overheating issue ?

    Now that my 9N starting issue seems to be resolved, I need to attack the overheating. Before, when I could coax it to start, it would get very hot very quick, run about a half hour and then stop dead. Efforts to revive even the next day were compromised by the ignition issues. It has been...
  13. M

    Afraid to try to start.

    IT STARTED RIGHT UP !!!!!! I just watched the connections for a while. cables all felt cool. Now to the overheating issue, will start a new thread after I read in the archives.
  14. M

    new ground cable terminal does not fit battery terminal.

    If I open the clamp enough to go over the positive post the bolt holes do not align.
  15. M

    is there a glossary for the shorthand you all use ?

    e.g. :what is OEM ?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top