Recent content by markfredi

  1. M

    1963 ford tractor gas distributor cap

    thanks guys--i appreciate your thoughts and advise. I will try to find the clip or use some silicon for temp fix
  2. M

    1963 ford tractor gas distributor cap

    thanks guys for your help. mine has the dust cover and it says arrow points to the oiler. I will recheck it later. i appreciate your help. Keith--you said, "There is a clip that goes on the shaft then the rotor. " is this clip required?--i may have discarded it cause i didn't know where it...
  3. M

    1963 ford tractor gas distributor cap

    I just installed a tune-up kit on my 1963 ford 4000 tractor. just a question. does it matter which of the two options to install the distributor cap--since it is 4 cylinder- it looks like you have two options on positioning the cap. the tractor was running when i parked it--like two years...
  4. M

    1961 JD 2010 (gas) electrical solenoid/alternator question

    thanks this was a big help. if you have any thoughts on the alternator i would appreciate it as well.
  5. M

    1961 JD 2010 (gas) electrical solenoid/alternator question

    thanks for your reply. it starts without the R wire hooked up. which terminal on the coil does it go? im assuming the same terminal from the coil to the distributor?
  6. M

    1961 JD 2010 (gas) electrical solenoid/alternator question

    I just installed a new solenoid due to the other one was broke. I took two wires off the main (larger) post--one was the positive to the battery and the other one was a wire that went to the start switch. there are two other small post--one post has a S beside it--that wire goes to the start...
  7. M

    850 overheating

    Just a thought--the radiator may need a professional flushing and cleaning. Mine was overheating. i took it to the radiator shop and he said the radiator was not circulating water properly--that fixed the over heating problem
  8. M

    JD 2010 hydraulic Lift problem

    Jim the filter looked bad. what is the best solvent to use to clean it? thanks mark
  9. M

    JD 2010 hydraulic Lift problem

    Jim the filter looked bad. what is the best solvent to use to clean it? Also, the manual said it takes 8 gallons but about 10 came out--is that strange? thanks mark
  10. M

    JD 2010 hydraulic Lift problem

    Jim the filter looked bad. what is the best solvent to use to clean it? thanks mark
  11. M

    JD 2010 hydraulic Lift problem

    thanks Jim, i found it. the lift did start working today. i've only started the engine a few times in the last few days since it set up for over a year. I will drain the fluid, clean the screen and put new fluid in it. again, thanks for your help
  12. M

    JD 2010 hydraulic Lift problem

    thanks Jim, where is the hyd screen located?
  13. M

    JD 2010 hydraulic Lift problem

    I've got a 1961 John Deere 2010. First let me thank all the folks that responded to my previous messages on different topics. Lots of great help to get my tractor running. Problem now: my tractor set up for about a year or so outside but covered. the hydraulic lift was up during the time it...
  14. M

    JD 2010 Gas

    Jim, thanks for your help and manual --I'm not sure what the safety start switch is? there is a wire from the coil to the distributor the other wire from the coil is not connected to anything. Also what is a ballast resistor (is that the white thing connected to the body that has like two...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top