(800) 853-2651
SHOP NOW

Recent content by Marmaz

Yesterday's Tractor Forums
  1. M

    Stanadyne Injection Pump

    Sorry guys, I thought I had John Deere 3020 with a Stanadyne pump typed in. I must have edited it out. Thanks for the replies.
  2. M

    Stanadyne Injection Pump

    I took my pump off for a rebuild and wasn t smart enough to line up the marks before I took it off. I know how to time the pump to the tractor. Turn the fly wheel to TDC and line up the marks on the pump. Did I screw up by not timing before removal?
  3. M

    Oil Pressure Adjustment Unstyled B

    It appears all I had to do was ask. Right after I posted, I found the adjustment screw. Its a long 5/8 hex cap and lock nut on the front of the governor. Remove the cap, unlock the nut, and turn the screw. Youre even able to do it with the engine running. I wonder why they went away from that to...
  4. M

    Oil Pressure Adjustment Unstyled B

    Anyone know how to adjust oil pressure on 35 John Deere B. The manual says to remove oil adjusting screw nut cap on from front side of governor, and loosen lock nut on adjusting screw. Problem is theres no picture and Im not sure what to look for.
  5. M

    JD 3020 Diesel

    Thank you, guys, for the advice! I figured it was some kind of fuel issue. Wasnt sure where to start. I guess I should have mentioned that I put a new fuel filter on (the square see through type), filled my tank, and checked connections.
  6. M

    JD 3020 Diesel

    The tractor starts and runs fine for a while. Eventually, the rpms will slowly slow down until the engine dies. I have the throttle opened all the way. This has kind of been an intermittent problem. It doesnt do it so the time. Usually, after the engine dies I simply restart and everything is...
  7. M

    John Deere B tranny broke

    Ha! I tried that but couldnt find a decent drill bit.
  8. M

    John Deere B tranny broke

    I wish I would have read this sooner. Youve helped me a ton so hopefully this helps in the future. Better late than never right? On those snap rings, pry them open with a flat screwdriver. Then stick another (flat) screwdriver in to hold open. Then pry up with second screwdriver and insert a 90...
  9. M

    John Deere B tranny broke

    Thanks again. Im going to have to find a puller to get that bearing out. I appreciate your help.
  10. M

    John Deere B tranny broke

  11. M

    Unstyled 1937 B Rear End

    Thanks for the reply. I took the top cover off. I noticed a gear missing some teeth. I flushed the transmission with diesel a couple times and got a couple of the teeth out. Ill try taking the brake off and see if I can find anything else. Ill try to get some pictures as well.
  12. M

    John Deere B tranny broke

    Lol, Im in Nebraska. Would B quite the trip.
  13. M

    John Deere B tranny broke

    [quote= Looks like I have the same problem. Unfortunately, I have some broken teeth. Id appreciate any help or advice you could give me. I dont know a lot about these old tractors. Did you document any of the rebuild process?
  14. M

    Unstyled 1937 B Rear End

    My B will not roll freely. I noticed when pushing it out of the garage. Transmission is in neutral. The tractor will roll freely until the wheels hit 12:00 then clunk clunk rolls free till 12:00 clunk clunk rinse and repeat. Ive jacked the rear wheels up off the ground and they spin freely and...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top