-
Baraboo 2024 Case Feature
Here’s some photos from Baraboo show.- masonfromwi
- Thread
- Replies: 2
- Forum: Case & David Brown
-
-
1953 Case VAC14 Grill Screen
In search of a Grill Screen for a 1953 Case VAC14 Thank you- masonfromwi
- Thread
- Replies: 3
- Forum: Case & David Brown
-
VAI Case - Only 2-3 PSI Oil Pressure
The reason why its showing little to no OIL PSI is because the 0-80 gauge, 10 is about just off the 0 so hopefully the 0-30 helps!- masonfromwi
- Post #32
- Forum: Case & David Brown
-
-
It's a leaker now
I would suggest replacing the oil pan gasket before the rear main seal.- masonfromwi
- Post #14
- Forum: Case & David Brown
-
VAI Case - Only 2-3 PSI Oil Pressure
I will stay tuned. Might be the gauge range. The little VAC’s normally had the 0-30 and should run 20 PSI- masonfromwi
- Post #28
- Forum: Case & David Brown
-
VAI Case - Only 2-3 PSI Oil Pressure
Hello. From what ive found is that all there is is that there could be a block anywhere in the oil system, oil pump is bad, main crank bearing is bad, or some item like that.- masonfromwi
- Post #26
- Forum: Case & David Brown
-
-
VAI Case - Only 2-3 PSI Oil Pressure
Hm. Very troubling. Let me check my manuals.- masonfromwi
- Post #22
- Forum: Case & David Brown
-
VAI Case - Only 2-3 PSI Oil Pressure
Hm. I would definitely make sure the pressure line is free and the pump doesn’t have a blockage in the oil pan. Good luck, PS, check your service manual for the best tips. Could be thick oil. Let’s of times.- masonfromwi
- Post #19
- Forum: Case & David Brown
-
VAI Case - Only 2-3 PSI Oil Pressure
Gauge could also be somewhat frozen up.- masonfromwi
- Post #15
- Forum: Case & David Brown
-
VAI Case - Only 2-3 PSI Oil Pressure
No problem. Make sure to check the pump to make sure there is no blockage and it is clear on the pump screen. Could be an issue in the pump and or the pressure gauge lines are blocked.- masonfromwi
- Post #14
- Forum: Case & David Brown
-
VAI Case - Only 2-3 PSI Oil Pressure
Where are you checking PSI?- masonfromwi
- Post #10
- Forum: Case & David Brown
-
VAI Case - Only 2-3 PSI Oil Pressure
Check gasket, some put form-a-gasket because they might of leaked to much. Or a block from the oil pump-stem- masonfromwi
- Post #9
- Forum: Case & David Brown
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy