-
M
Handyman all purpose jack Warning
Be careful with those jacks. I got cold cocked in the side of the head with the handle this afternoon, I stayed upright and didn't go down but it was close. I can open and close my mouth and have all my teeth. I will probably be black and blue tomorrow, kept ice on it for three hours' Just make...- muleman51
- Post #1
- Forum: Tractor & Farm Talk
-
1586 clutch pivot
This pivot bracket broke on the 15, Is there a reason I can't pivot it off the bellhousing. I just put in the silver bolt so I could move the tractor. Is there suppose to be something from the 3/8 hole on the original pivot to the 5/8 ? hole on the bell housing to help support it. The bracket...- Moline_guy
- Post #1
- Forum: Farmall, International & McCormick
-
M
which port is pressure in front steering cylinder ?
Im replacing the original power steering cylinder in my 4400.....its in the front bolster and it is for the power steering ...this one is a little different than the original one ...I also looked at my 68 4500 and its not the same cylinder , so I can't compare it to that one......question... -
J
What to do with my Super C fuel system
My Farmall Super C will not run smooth unless I choke it about halfway. Even at low idle, it does not run smooth unless choked halfway. When I quickly open the throttle as suggested by Steve at advance, the engine sputters without the choke, but with the choke, it runs fine. When the...- JohnV2000
- Post #1
- Forum: Tractor & Farm Talk
-
M
Front end loader for 1948 Ford 8n
Hi I just bought a 1948 Ford 8n with original snow blower for a moderate price. I am in the process of moving and starting a small hobby farm out here in the country. I am new to tractors and am looking for some advise on the type of loader that would accommodate my needs. I won't be...- mauditfou
- Thread
- Replies: 5
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy