Recent content by mcline5

  1. M

    M valve clearance

    Yea if you see recent post,iam on a m john deere. Although internet still suggests 17
  2. M

    M valve clearance

    Ok ,maybe this is issue, iam working on m john deere. Not m IH. Can I get some feedback. Thanks
  3. M

    M valve clearance

    Yes sure did,dont mean it may need some more
  4. M

    M valve clearance

    Here is why I am confused with your alls valve clearance specs. Makes it difficult in what to believe.
  5. M

    M valve clearance

    Thanks, done some more searching and says 17 or 20 cold also from previous post on here. Going to adjust tomorrow. Valve clearance shouldn't be the cause of little excessive blow by but may if compression to high and going past rings. Was just overhauled and I know I should take it out when...
  6. M

    M valve clearance

    Oh someone needs to come clean, where are you guys getting 17 20 valve clearance. Every manual i read says 12 cold. I've just did a overhaul and wanting to specs but surely dont know what to believe. Mine runs good at 12 but a bit hard to start cold. Also have some blow by no smoke on exhaust...
  7. M

    M john deere axles

    Hello new to site. Restoring a m john deere and rear axle stubbs take different nut . Left side is 11/2 right is 2 1/4. Is this normal or what's the deal. I belive all seals will work for john deere catalog doesn't show right final. Thanks
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top