-
M
Ford 641 broken pto
Thank you for the advise. I will give it a try and post the results.- medforce
- Post #9
- Forum: Tractor & Farm Talk
-
M
Ford 641 broken pto
My thoughts are to get a bigger hammer. Am I wrong?- medforce
- Post #4
- Forum: Tractor & Farm Talk
-
M
Ford 641 broken pto
The bearing retainer and a peice of the shaft. I used a pair of chanel locks to reach in and pull on the shaft but it wouldnt budge. Then took the pto lever side plate off and grabbed it but it wouldnt budge. The used a long screwdriver to tap it from the pto lever hole towards the rear and it...- medforce
- Post #3
- Forum: Tractor & Farm Talk
-
M
Ford 641 broken pto
I have a 1957 641 that has a broken pto shaft. I have a replacement part but cant get the old pto out. It broke at the rear when i raised my bush hog too high. I have the rear most section out but the part inside the tractor wont budge. I have removed the sideplate ant tried to drive it out but...- medforce
- Thread
- Replies: 10
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy