Recent content by meihman

  1. M

    WD-9 not firing

    with valve cover off, you will notice a third valve with its own rocker arm. make sure the rocker arm is turning and that the valves are openning and closing. these valves drop the compression. if they are stuck open then it wont fire on diesel. since it is running on gas the valves are not...
  2. M

    dead in the water

    if you have rewired everything then it sounds as though the starter switch is the problem.
  3. M

    WD-9 Hood

    I actually should have asked what is correct. I have 2 T-bolts that came with the tractor but i thought they were something that someone had made up. i use them. i have found mixed thoughts on what is factory & what is not. i'll have to make up a couple of more with threaded rod.
  4. M

    WD-9 Hood

    Thanks, mine didn"t have anything attached to it.
  5. M

    WD-9 Hood

    What is used to hold it in place?
  6. M

    Pics of my 1468 and 1568

    do they still idle on 4 cylinders? a lot of those had been changed to idle on all 8.
  7. rrlund

    what caused glow plugs to do that?

    I always have a few glow plugs burned out of my 6.9 Ford every year,but it's sporadic,no pattern to it. Last year I changed the whole set and it had never started better. Well,this year it was starting hard again in cold weather.I'd been having to plug it in for the past few weeks. I checked...
  8. M

    W9

    1. The clutch throw-out bearing can be reached by first removing a round plate located on top of the clutch compartment cover (towards the left side of the tractor). I will have a look at mine to see about the packing nut for the water pump.
  9. M

    Clutch on a Super M

    The clutch on a Super M is 12". The tractor would have to be split to change it. (M is 11" clutch by the way).
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top