(800) 853-2651
SHOP NOW

Recent content by MG-8n

Yesterday's Tractor Forums
  1. M

    8n pto

    Thank you Jim That helps me out, I guess I just didn't know how it worked with the clutch, But that way I can use it, Thank you again.
  2. M

    8n pto

    It has a cover on it now but I would like to use it in tha future, can I conect something to the pto and then start the tractor? that does not seem too safe, I would like to fix the lever, Just looking for some advice on what to look for. and how to go about it, Not coments on the obvious...
  3. M

    8n pto

    I have an 8n and this spring I was looking into the PTO release lever stuck in the on possion and it will not move, last fall I split the tractor apart about 2" and got the lever to free up, but as soon as I pull the tractor back together the lever was stuck again, Any thoughts on what the...
  4. M

    8n hydrolic optional hookup

    I am wondering if on the 8n there is an extra port off the pto hydrolic pump that can be used for a wood spliter that mounts on the 3 point hitch. any thoughts Mark
  5. M

    fuel bowl gasket

    I just had to cut my own out of a flat piece of rubber sheet, works great
  6. M

    white foam in oil fill neck

    I have had the same issue with the white foam in the filler tube and cap, There are some times I don't run the tractor long enough. thanks for all the info, this is a good site, I enjoy rooling through the input and learn alot. Thanks Mark
  7. M

    3 point lift hydrolics

    well I got time today to look at the 3point lift, I checked the lever rod it was in place, so I removed the cover again and followed the fluid flow and found that the cylinder is held onto the cover by 4 bolts and relized I left them loose after I loosened them in case they were holding the...
  8. M

    3 point lift hydrolics

    My pto is still turning and I have no lift, I only put fluid in the front resivor, does it take a little while to reach the lift? I am fairly new at the 8n thing, and I have ordered the manuale's but it takes a couple days to mail. I am excited about my tractor so please dont upset if I ask to...
  9. M

    PTO on-off lever bound up

    Well I had the tractor split today, and got the lever free, but when we pulled it back together the lever bound back up, What could it be? all the gears and shafts look good, the hydralic fluid was nasty, not a lot of sludge.
  10. M

    fan blade hits the sroud and radiator

    Thank you for the ideas, I was looking at the front end and found that the previous owner installed a suport fram for a plow on some brakets using the same bolts that hold the braket that holds the radiator, and the bolts were loose. plus i had a litle reshaping of the shroud. Mark
  11. M

    fan blade hits the sroud and radiator

    This happens when I get on a agressive and uneven incline, I know stay away from them, But is this normal and to what exstence?
  12. M

    8n PTO lever on left side under seat

    Thankyou for your input, I can't wait to take a look behind the cover. I hope that is as far as I need to go for now, But spliting the tractor is something I want to do before to long, I just have some work to do this spring first. Mark
  13. M

    8n PTO lever on left side under seat

    The spline is 1-3/8 from top of spline across to top of spline opisite. I would like to be able to run PTO in future, what would you sugest for me to do to determine if it is possible. This is my first tractor, I am enjoying it. sofar I have rewired it, put on a new manifold, and basic...
  14. M

    8n PTO lever on left side under seat

    Thanks for the reply's I thought it was a PTO on or off, I had a cover on the PTO shaft, pulled that off and my PTO is on all the time, I may want to use this later, will that be a problem? and is there a way to disengage the PTO for now?
  15. M

    8n PTO lever on left side under seat

    I have recently became the proud owner of I beleive to be a 48 8N and the PTO lever under the seat on left side seams to be locked up, I removed the PTO cover today and the PTO is on. I believe the lever is to turn off the PTO, What might be tha cause for it to be stuck?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top