(800) 853-2651
SHOP NOW

Recent content by Mike L

Yesterday's Tractor Forums
  1. A

    Wallis Tractor

    Does anybody know the year of a Wallis Tractor SN# 54972? How about an approximate value for a tractor that may be locked up but all there. I looked at one today that is sitting in the tree row.
  2. M

    m camshaft

    what is the advantage of a super M cam???
  3. M

    Side rails on a M

    Heat them up with a torch make them red hot let them cool do this three times on the fourth heat use a wrench and turn them out. if you dont have a torch leave them alone.
  4. M

    spark plug won't turn

    dont use the impact wrench it will make your blood preasure go way up dont ask me how i know
  5. M

    Starter 12v or 6 v

    Take it to a starter repar shop they can rebuild it for half what a new one cost. ben there done that !!!!!!!!!!!
  6. M

    Bull Gear M

    I did it that way on an H Slid the axel out about 4 inches and pulled the gears H and M Farmalls are simular in design.
  7. M

    Tractor Drive

    Tomorrow is the big day my M and I will atempt to drive 42 miles through Warrick County Indiana There is a buch of us antique tractor lovers going on this ride. Wish me luck............
  8. M

    Char Lynn PS problem

    I have char lynn power steering on my 52 M it leaked just like what you have decribed. The one I have has O-rings and washers in each end. The washers along with the O-rings were destroyed by time and use. I replaced them with new O-rings from NAPA. I put two O-rings on each end and discarded...
  9. M

    noisey hydraulics on Farmall H

    Most trip loaders have oneway cylinders (meaning there is only hydrolic pressure moving the loader up).When you let the pressure off the loader moves down from the weight of the bucket. The ones I have had droped so fast they slamed the ground when I let the pressure off. And they all made noise...
  10. M

    Hydraulic pump drive shaft on an H.

    You must remove the pump from the tractor. Remove the pump from the oil resservoir. place a 1/8 x3/4 x 6" bar through the hole in the top of the pump to lock the gears.the coupling has right handed threads. National seal # is 357970 Car quest # is 470135 Good Luck
  11. M

    IH 766 Clutch Problem

    check the hydrolic level.
  12. M

    Super A and Brush Hog and 3pt or pull behind

    Pull behind its alot easer on the tractor
  13. M

    Brake seal on Farmall H?

    I have the seal #s if you need them
  14. M

    ot/ east coast disappointment

    Boonville Indiana Has a Thresherman Park July 27-28 antique tractor show its awesome they have it every year.Parades pulls demonstrations and so much more.
  15. M

    Early M hydraulic problem

    Name: Mike L (Reserved Name) E-Mail: Subject: Re: Early M hydraulic problem In Reply to: Early M hydraulic problem posted by chris klein on July 10, 2008 at 13:36:03: Body of Message: You can get a breather plug that goes in the cylinder where the return hoes goes. This will turn your twoway...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top