(800) 853-2651
SHOP NOW

Recent content by MikeGreen830

Yesterday's Tractor Forums
  1. M

    730 clutch drive disk bolt

    Can anybody out there help me with the torque spec for the clutch drive disc bolt on my dad s 730 2-cylinder diesel?
  2. M

    830 hood

    Thanks, appreciate it!
  3. M

    830 hood

    Anybody out there fabricating new hoods for 830 2-cylinders?
  4. M

    JD1276 rims

    Does anyone know if the JD1276 rims from John Deere are the same as the original JD1276R rims that are on my 830 2-cylinder?
  5. M

    Thrust bearing 730 2-cylinder power steering

    When installing a new thrust bearing in the bottom of the spindle quill, how far do I need to drive it? Flush with the bottom of the quill or seems to me there was a lip inside, possibly driving it down to that lip? I'm not in front of it at the moment so not sure how deep that lip is. Any help...
  6. M

    830 2-cyl rack stuck ?

    I figured that would be the case. I appreciate your insight.
  7. M

    830 2-cyl rack stuck ?

    No rust. It's been sitting for about 25 years. I've heard sitting with stale fuel will cause them to stick.
  8. M

    830 2-cyl rack stuck ?

    Ok, the rack on the flywheel side seems to be stuck. The rack on the pulley side moves easily with good spring back. I have the throttle wide open. I can move the flywheel side rack towards the pulley side with a little effort using a screwdriver as a lever but with the flywheel side rack not...
  9. M

    Another 830 2 cyl ES question (seized)

    Thanks, buickanddeere! Hope to look into it this weekend and see what's going on in there.
  10. M

    Another 830 2 cyl ES question (seized)

    Thanks for the encouragement, Kendall!
  11. M

    Another 830 2 cyl ES question (seized)

    Ok, so when I turn the flywheel towards the front of the tractor, it acts like it is hitting something and when I turn it towards the rear as far as I can, I hear a slight squeak, like maybe metal on metal and it gets stuck. I put muscle to it and can get it unstuck. If it was freed up, I should...
  12. M

    Another 830 2 cyl ES question (seized)

    Tried it again this morning with the tractor out of gear and still only able to turn it one way or the other about a quarter turn or more. Not sure if this is a good sign or should the flywheel turn all the way around by hand?
  13. M

    Another 830 2 cyl ES question (seized)

    Oops I didn't take the tractor out of gear, that makes sense now. I'll try again tomorrow. Should I be able to turn the flywheel all the way around by hand in neutral then?
  14. M

    Another 830 2 cyl ES question (seized)

    I should have mentioned I turned it by hand.
  15. M

    Another 830 2 cyl ES question (seized)

    Ok, I took the flywheel cover off and with the decompression lever held back, I could turn the flywheel about a 1/4 turn or more each way. When I turned it towards the front of the tractor when I got where I couldn't turn any further it acted like it wanted to pull the tractor forward. Is this a...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top