(800) 853-2651
SHOP NOW

Recent content by Minniemo

Yesterday's Tractor Forums
  1. M

    o/t how old and where

    68 South Western Ont. Just East of Windsor.
  2. M

    Duals and snowplowing

    I have a Minneapolis Moline 335. I had to have wheels repaired and I didn't refill with calcium. It makes quite a difference for pushing snow and pulling the disc, but so far the old girl is still doing a good job. Here in South Western Ontario we got between 6 and 10 inches over the last...
  3. M

    OT - WHERE YOU FROM?

    Sun Parlor of Canada. Essex County.
  4. M

    old Briggs Stratton very hard to start

    I have an old Briggs & Stratton model ZZ engine. It starts, but is very hard to start. It seems that gas is not getting to plug but the carb is flooding (gas running out). I use another engine to turn it over. Probably, after about 3 minutes of steady turning it started, ran for about 2...
  5. M

    old briggs stratton very hard to start

    I have an old Briggs & Stratton model ZZ engine. It starts, but very hard to start. It seems that not enough gas is getting to plug but the carb is flooding (gas running out.) I use another engine to start it. Probably after about three minutes of steady turning it started, ran about 2...
  6. M

    B/S won't keep running

    Thanks Jim. I will try that.
  7. M

    B/S won't keep running

    I have a Briggs & Stratton 3.75 on a lawn mower. It will start up OK but won"t keep running as if starving for gas. I don"t see any adjusting valves eg. air/gas. Any info appreciated and thanks in advance.
  8. M

    Remove throttle spring 335MM

    Thanks T.R.K. Do you remember if the part that the plastic cone fits in, unscrews from the tractor. I'm wondering if the roll pin at the bottom of the shaft could be replaced with a cotter pin if I ever get it out? Minneapolis definitely did not make this too user friendly, did they?
  9. M

    Remove throttle spring 335MM

    I have a Minneapolis Moline 335. The throttle does not stay down on its own. I have to hold it down. Does anyone know how to fix this problem or the steps to removing the throttle arm to get at the spring behind the dash? Any help appreciated.
  10. M

    Throttle arm/spring

    I have 335 Minneapolis Moline. When I pull the throttle it will not stay down. I have to hold it all the time. Does anyone have an easy fix for this problem or does anyone know how to get throttle arm off easy? There is a spring under the dash on the throttle arm. Any help will be...
  11. M

    When the Wind Blows

    What a wonderful way to start off a day Thanks
  12. M

    Happy Thanksgiving (Canadian)

    Happy "late" Thanksgiving from Southwestern Ont (Tecumseh)
  13. M

    rusty gas tank

    Hi folks: I have a rusty gas tank off an Empire two wheel walk behind. Does any one have a good method of getting the rust out of the inside of the tank? Thanks in advance for any suggestions.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top