(800) 853-2651
SHOP NOW

Recent content by mite-help

Yesterday's Tractor Forums
  1. M

    OT- genie manlift.

    THanks
  2. M

    JD 2020 load shaft seal/retainer /shaft kit

    ok. we don't have the retaining collar & other pieces for 1 side
  3. M

    JD 2020 load shaft seal/retainer /shaft kit

    thank you!! will go to where the tractor is today & see what i can make out
  4. M

    JD 2020 load shaft seal/retainer /shaft kit

    Is there any other place to find vin # other than tag on frame rail?
  5. M

    OT- genie manlift.

    thank you for your reply. yes i will see if i can find some test specs for those motors. they are 24v, but i don't know if it changes from a lower voltage for slower speeds? about the same set-up as a golf cart i would think. yes, before i buy the right batteries, i need to make sure the drive...
  6. M

    JD 2020 load shaft seal/retainer /shaft kit

    thank you sir. vin tag is bent over will try to make it out today
  7. M

    JD 2020 load shaft seal/retainer /shaft kit

    HELLO ALL . I am looking for the loadshaft seal kit for this JD 2020 . i can find kits on line [including this store] but they all jump over 2020, with some pictures looking like what i need. any interchange with other models ? thanks
  8. M

    OT- genie manlift.

    hello all--did;'nt know where to post this, so here goes, as i know a lot of you have golf carts with 48v system. i recently came up with a genie manlift, it had no batteries. just to try it out, i installed 4 known good 12v g31 truck batteries. all functions came alive & work great except...
  9. M

    Points striker wear?

    i can't remember the brand, but one mfg. put a small capsule of grease in box with points. friend of mine said to take it with a glass of water before you began to steady nerves LOL
  10. M

    Kubota L5450 issue

    howdy-- try Kabota parts America for discontinued, obsolete parts. they have a website. you will need the part no. to do a search. good luck!
  11. M

    D14 Problem

    yeah---try moving power divider lever full forward ,than pull full back for low--also check fluid level in this box--
  12. M

    d 14 transmission removal

    hello--trying remove transmission-axle assys off,& pto. pulled all bolts from trans to power director-unit will slip back, almost disengage p-d shift fork, will come no more. does fork & cross shaft have to be removed, & clutch unit come out with trans? thanks for help
  13. M

    What would you do

    if that rim has rust scale poking holes in tube, probably berryman won't seal either. I would clean rim up real good-[short of sand-blast, heat [torch] will pop that rust off, than wire brush, coat with spray-on bedliner] put powder on tube @ assembly
  14. M

    installing perkins sleeve

    hello all--this weekend i plan to install a sleeve a flange type sleeve in 336 perkins. i have build a fixture to press it in. i plan to use 640 sleeve retainer, pack sleeve in plastic bag with dry ice. question came up about cold messing with loctite. did this years ago, but it was less press...
  15. M

    sleeve retaining compound

    helping installing sleeves in mf 135 diesel engine. notice #3 is gonna be light on press fit. i ran into this once before, & used a 'loc tite' type product, can't recall what it was. what do you folks use?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top