-
M
O T Electrical question
¾” should work but 1” will be easier to pull if you have bends.- MLP
- Post #1
- Forum: Tractor & Farm Talk
-
M
Roll Bar
ROLL OVER NEW HOLAND Ford 2N 302538 - 2-post $490 Ford 8N 302538 - 2-post $490 Ford 9N 302538 - 2-post $490 Also look here. ROPS selector- MLP
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
OT-Electronics and Warts
Unregulated wall warts are designed to work at a specific load. If the load is too light then the out put voltage will be too high. For example a 9VDC 500ma wart may be putting out 16VDC at a 50ma load. I some times use them this way when it is a none critical application. A regulated wall wart... -
M
OT--Stuff in the Sky
Right now it is only about 212 miles high. You can check here. http://spaceflight.nasa.gov/realdata/tracking/ Human space flight- MLP
- Post #1
- Forum: Tractor & Farm Talk
-
M
I got banned!
You can remove just the cookies for that site if you need to save your other ones. You could also use another machine at a different location incase they are blocking your IP or you can use an anonymous program they cost a few bucks a year but work real well. I tested one out and no one could...- MLP
- Post #1
- Forum: Ford 9N, 2N & 8N
-
M
9n Dummy Coil
I pulled the pins on mine hollowed it out and used a section of plug wire to connect the two ends together. I now use a 40,000-volt round can 12-volt coil, which could be mounted out of sight, but mine is in plain view. This is on a 2N and has been working fine with no cleaning or adjusting of...- MLP
- Post #1
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy