(800) 853-2651
SHOP NOW

Recent content by molinemuscle

Yesterday's Tractor Forums
  1. D

    Update on daughters motorcycle wreck

    Keep those prayers a coming cause they are working....from not knowing if she was gonna make it to eating 1st taste of food today..applesauce....30 days today..god an prayers is working miracles...still not totally emerged but is walking to bathroom with help.hanging on to belt..an...
  2. K

    Farmall 504 Gauges

    None of the gauges work on the Farmall 504. I'd like at least temperature and oil pressure. (Original was a combination with idiot light for oil). suggestions?
  3. P

    MF 202 and MF 304 industrial tractors

    My MF 202 work Bull shuttle shift transmission with front loader & backhoe. Transmission only works if rpm is increased & then tractor lurches however if my foot raises either forward or reverse pedals tractor moves normally. Is this just a linkage problem? I also have a MF 304 industrial...
  4. W

    Old Hay Field

    What's the best mower to use on a hay field that hasn't been cut in 4 years. Brush hog Or a hammer knife mower, or something else.
  5. C

    Ford cl340 skid steer

    Hi I am kinda new here I bought a Ford CL340 skid steer with a wisconsin engine I know they made them between 71 - 73 but not sure what year is mine it has 2 serial numbers 340 is one and the other one is 2050 Help!!!!! Thank you :roll:
  6. D

    JD 730 gas throttle

    Tightened the 5/8 bolt on the throttle lever twice and it is still limp on mid throttle......is there a simple fix without removing hood or dash panel.
  7. W

    Ferguson TO20 12 volt conversion

    Hello, Ferguson TO20 owners. I've installed the 12 volt conversion kit and the pertronix ignition kit from Yesterday's Tractor. The kit contained a new wiring harness and diagram so all the old wiring was pulled out and the new installed. My problem is that when wired as instructed, the tractor...
  8. K

    Case 600 Bosch NSB6A

    Trying to get our tractor started after sitting in the barn for 9 years. Ran when parked. New fuel and fuel filters and bled. Should the transfer pump on the side of injector pump run diesel out when cranking? Couldn't get it to start, so I unhooked the fuel line out of the pump and...
  9. K

    1929 GP Trans Splined Shaft Troubleshooting

    Hello all! It has been a while since I have posted in any of the forums, but am always reading... I need help. I am helping a friend with his 1929 GP.... We had to replace the splined shaft in the transmission. Let me first start by saying I was not involved in every step of the process on...
  10. 8

    3000 Generator Amature Wire HOT

    Last year the Ford 3000 voltage regulator went out. I did all the tests and replaced it. It worked fine for the past year since then. Now the generator light is back on and at 1200 RPM the voltage at the battery doesn't change at all from 12.6V. So I disconnected the field and armature...
  11. Geo-TH,In

    One well problem solved only to find another problem.

    I thought my very old 120v myers jet pump died only to discover it has a bushing that has never been oiled. I oiled the bushing and the pump is very quiet and pumps water. It can only make 25 psi max so I adjusted the pressure switch and used it during the power outage. July 29, 2012 I had...
  12. D

    Ford 8730 Transmission errors

    I have a Ford 8730 that will not down shift. It always defaults to 7th gear when the key is cut off and then back on. It will move forward and reverse and will up shift. It s giving error code U3 and while driving it gives error code P5. I also can not get it into calibration mode. I assume...
  13. H

    John Deere 345

    When i lift up on the RIO switch and touch the reverse pedal, the mower deck turns off. I made sure there is continuity through the switch when lifted up. Power is there until i touch the pedal...is the board bad?
  14. R

    The Zane Thang

    Trying to locate a Zane Thang for my 9N. Anyone know if they are still available? Ray
  15. M

    Seat cushions

    Looking for a vendor for seat cushions for a RTI. Thanks, Mark
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top