(800) 853-2651
SHOP NOW

Recent content by Money Pit

Yesterday's Tractor Forums
  1. M

    Blade Or Bucket For Snow removal

    Thanks everyone; lots of good feedback. I should have clarified in my original post the tractor is a BX2380; about 23hp so not a large tractor. I also still have the 5' blade that has some plates at the ends so it does contain some snow. Think I'll start out using the blade to make piles until I...
  2. M

    Blade Or Bucket For Snow removal

    Bought a small Kubota with a bucket. one of the tasks will be snow removal. had been using a ford 2000 with a back blade. moved snow OK as long as I took reasonable bites and didn't try to exceed the traction limits. but then there was the twisting around in the seat to see what I was doing. so...
  3. M

    governor rebuild

    8n side mount. posted some time ago about this tractor not idling down consensus was governor problem. so planning on pulling it and get a rebuild kit. couple of questions first how hard to rebuild these? any special tools needed? second; tractor is 2 hours away. plan on pulling the gov and...
  4. M

    sprayer suggestions

    garlic mustard is the first plant to green up; weeks ahead of everything else. that's when i spray so the collaterall damage is minimized.
  5. M

    Time for work

    just retired in January 63 years and 11 months old. went with Cobra from the company. using the federal mileage reimbursement rate of 55 cents a mile and the miles i put on each day those savings by not driving are covering most of my expense. probaly even better now with the gas prices.
  6. M

    sprayer suggestions

    have a lot of invasive plants on our land (wooded hilly with a good amount of logging trails) want to get a 12v sprayer to apply roundup. have a carryall to use behind my 8n (converted to 12v) that i would use to carry the sprayer. thinking i could get to most of the areas from the drivers seat...
  7. M

    chains on concrete

    ford 2000. rear blade. ladder chains. no ballast. was very obvious that current setup will not cut it. good point on not spinning the tires.
  8. M

    chains on concrete

    First snow with a new concrete drive. Got the results I was expecting and dreading. Need better traction. Looks like Ill have to chain up. Heard about how bad chains are on concrete that they tear it up. How bad can it really get? I can put up with some surface blemishes but does any damage...
  9. M

    MarkB_MI / Tranny addative

    thanks Mark. got a car that acts a little weird tranny wise hope this would help.
  10. M

    MarkB_MI / Tranny addative

    a few weeks back there were some posts about hauling a boat south with a car with a tranny shudder. there was some kind of snake oil addative that was only a few onces that you used if memory serve right. what was that addative and di it help?
  11. M

    Selling Tools

    thanks to all for the feedback. i still need toi make an itemized list. would greatly prefer to sell it all as a lot. think i'll shoot for the lower side of half price and go from there. tech schools soiund like a good idea.
  12. M

    Selling Tools

    retired tool and die maker; have my set of tools that I have no intention of using again. staying retired! that being said it's time to sell them off. wondering how to fairly price things. while nothing in the set is new; most of it is in very good condition. I've been looking at new tool...
  13. M

    8n wont idel down

    OK; got to spend some time with it this weekend. Without the engine running the throttle is at rest on the stop for the idle adjust. Start it up and it goes to high idle. Seems like it gets worse higher once it warms up. Can get it to a slow idle by pushing the carb to governer rod...
  14. M

    8n wont idel down

    thanks for all the replys. wont idle down: i move the throttle to the lowest / slowest position yet the engine keeps running about half speed. not a ne wproblem just getting tired of dealing with it. sometimes the engine will eventually idle down on its own. i can manually move the governer...
  15. M

    8n wont idel down

    8n side mount distributor. turn the throttl down all the way but engine keeps running about half of full speed. tractor is 2 hours aay wont be bale to check it until next weekend. hoping for some ideas on what top look for. thanks .
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top