(800) 853-2651
SHOP NOW

Recent content by Morgan Flowers

Yesterday's Tractor Forums
  1. M

    New Holland 644 hay roller

    I have a NH 644 hay roller. When the roller is full it will not automatically go into tie cycle. If you press the manual lever down it ties perfectly. Any ideas why it won't automatically go into tie mode? Thanks
  2. M

    John Deere 310A No hydraulics will not move

    I have a John Deere 310A backhoe loader that will not move and has no functioning hydraulics. It started out acting like the clutch was "slipping" and then a few days later it quit moving altogether but the loader and backhoe still functioned. Now all hydraulics have quit as well. Here is...
  3. M

    Small pickups

    Ford Ranger any years 2.3 or 2.5 4 cylinder 5 speed
  4. M

    Zero Turn Hydraulic Help

    These are all good replies. I have been working on it in my spare time and I am starting to think the pump or motor is bad as JD Seller suggested. The hose was made locally and perhaps there were some rubber shavings in the hose that made their way into the pump or motor. There is a return line...
  5. M

    Zero Turn Hydraulic Help

    I am working on my aunt's Derby ZT2354 (Ferris) zero turn mower and am looking for some advice. At the start of the summer the mower was working great but one of the hydraulic hoses going to the right wheel motor was leaking (it has 2 pumps and 2 wheel motors but 1 reservoir). I replaced the...
  6. M

    OT Ford Ranger AC

    Check the air gap on the compressor clutch also, it could cause it to not cycle correctly. It can be adjusted with shims (washers) if this is the problem.
  7. M

    1997 f250

    Is it titled as a 97 or a 98? 97 wouldn't have had a 5.4 engine and if it is a 98 then it will most likely be a 7 lug F250 which is basically just an F150 with a slightly beefier suspension and axle with the same drivetrain as an F150. 1998 was a transition year from the square body trucks to...
  8. M

    What is This ???

    Walnut Cracker?
  9. M

    Keystone Air Compressor

    Good idea- I will check it out. I'm learning as I go- this is my first experience with air compressors. I am going to air up the tank from a distance before I put the engine on it just to make sure it is solid with no leaks.
  10. M

    Keystone Air Compressor

  11. M

    Keystone Air Compressor

    Here are some more pictures if anyone can tell anything else about it? The tank says it was made in 1962.
  12. M

    Keystone Air Compressor

    I am thinking my 16 hp engine will have more than enough power so I was thinking I could run it at a lower rpm and get a bigger pulley (maybe 6 inch). But I may go with a 4 inch pulley since the compressor is so old it may not like getting up close to 1k rpms. I will add some pictures later that...
  13. M

    Keystone Air Compressor

    Thanks for the lead, I will check into it!
  14. M

    Keystone Air Compressor

    I have an old Keystone air compressor that I just bought with no engine. It had a gas engine of some sort on it but that is all I know. I have added some pictures of it also. Does anyone know what RPMs I should run this thing? I have a 16 hp Kohler engine I am using but need to know what pulley...
  15. M

    Too much oil pressure?

    My vote is the oil pressure sending unit is bad- I've had it happen a few times on systems with automatic alarms/shutdowns.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top