-
M
1965 ford 3000
I left out terminal 1 because it's the power into the key switch. I have to get a longer starter cable going to the solenoid tomorrow to wire it up correctly. Then hopefully everything is correct and I can put it to work again.- motorcycle_6066
- Post #18
- Forum: Tractor & Farm Talk
-
M
1965 ford 3000
Key switch has 5 terminal positions Key off- no active terminals Key position 1- #2 terminal has power Key position 2- #2 and 4 terminal has power Start positions- terminals 2 and 4 no power terminal 3 has power Start position 2- terminal 5 gets power Should I wire coil direct to terminal 4...- motorcycle_6066
- Post #16
- Forum: Tractor & Farm Talk
-
M
1965 ford 3000
Il try that this weekend when I get some time to work on it- motorcycle_6066
- Post #15
- Forum: Tractor & Farm Talk
-
M
1965 ford 3000
Should I only have 1 wire coming from the key switch to the solenoid? If so would that be going through the neutral safety switch? This tractor has been a wiring nightmare since we got it. So neutral safety switch to s side of solenoid an to the #5 pin of key switch. Then coil to the I terminal...- motorcycle_6066
- Post #13
- Forum: Tractor & Farm Talk
-
M
1965 ford 3000
Starter and battery is switched Battery and starter are switched sides the S terminal has the neutral safety switch the I terminal has coil wire and a wire running to the key switch.- motorcycle_6066
- Post #11
- Forum: Tractor & Farm Talk
-
M
1965 ford 3000
- motorcycle_6066
- Post #6
- Forum: Tractor & Farm Talk
-
M
1965 ford 3000
I forgot to mention that it is indeed a gasser. So I need to move the wire from #3 pin to #4 or run a new wire just for the coil and get it off of the starter solenoid.- motorcycle_6066
- Post #4
- Forum: Tractor & Farm Talk
-
M
1965 ford 3000
Need some help with wiring. Put in a new key switch and starter solenoid. Its no longer starting. Pin 1 comes from battery 2 and 4 isn't used 3 goes to battery side of solenoid along with coil wire. Pin 5 goes to neutral safety switch then it goes to the starter side of the solenoid. What did I...- motorcycle_6066
- Thread
- Replies: 17
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy