(800) 853-2651
SHOP NOW

Recent content by Mountain J

Yesterday's Tractor Forums
  1. M

    Early john deere a cylinder block

    Hi thanks for the info would it be possible to get a contact number or a link to the page please
  2. M

    Early john deere a cylinder block

    Good day everyone I am looking for a good used, reusable cylinder block for my AR casting number is A2324R I believe that's also the part number any info and leads will be greatly appreciated thanks
  3. M

    Hydraulic hose wrap

    Now that right there is cool
  4. M

    Plow rear wheel perhaps

    Got this Ferguson plow and I am wonder if there was an option for a rear wheel for a more consistent debt thanks for any info
  5. M

    7120 not moving

    Yes power steering and hydraulics work
  6. M

    7120 not moving

    A friend has this 1988 7120 mfwd he was using it and stopped when he went to go again there was a no go, not moving in forward or reverse, what could be the issue and where do we start diagnosis thank you
  7. M

    The Old and the New

    Sorry there it is now thats very cool thank you
  8. M

    The Old and the New

    No picture of the percherons???
  9. M

    Farmall m steering stop

    I think i will go with your advice with the washers instead of shipping cause shipping is a pain nowadays
  10. M

    Farmall m steering stop

    Deltared where are you located just wondering if it would be feasible sending me one
  11. M

    Farmall m steering stop

    I swapped a narrow front steering pedestal onto a m and was wondering were the steering stops are, the tractor i took the pedestal off had no stop you could steer it all the way till the steering wheel disconnected from the steering gear, I would appreciate some pictures of a narrow front m if...
  12. M

    Farmall 100 fluctuating

    Hi my farmall 100 idles nice and smooth till about half throttle from half throttle to full throttle it fluctuates bad worse at full throttle what have I got wrong
  13. M

    For John T or Old school me on ballast resisto

    Again I thank everyone for the input I am learning here and I now have lots of info to chew on so to speak, love the forum lots of good info, money saving info!!!!
  14. M

    For John T or Old school me on ballast resisto

    Wow wow a lot of info for sure, but I asked for it haha, thank you very much to everyone who replied I am gonna have to read and reread John T's post a few times then do some experiments and reread it a few more times again I thank everyone, now I will try to post a picture is this what you mean...
  15. M

    For John T or Old school me on ballast resisto

    Hey guys looking for more info on and about a ballast resistor I am in canada so no orielys up here and the part number will not work at the local napa so what I needs is a 1.6 ohm ballast resistor is this correct and another question will I see a voltage drop after the resistor with a...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top