(800) 853-2651
SHOP NOW

Recent content by mpriar

Yesterday's Tractor Forums
  1. M

    farmall cub front crank seal

    Do any of you know the IH number for the front crankshaft seal? Thanks
  2. M

    cub/cub lo boy

    Guys, is the fast hitch setup the same for these two tractors? Thanks
  3. M

    old old fordson

    Dad and I bought an old fordson and it has attachment on it. We think it is part of a loader or blade. Are we correct? Thanks
  4. M

    Massey harris 101 super

    Hi guys, what does the 101 super compare to, as far as weight size, etc.? Have found one close to home but dont know much about them. Have a 333 and pony, so familier with MH, just not this model. Are they close to a farmall h or m? Did read that they are pretty fast in road gear. Are they rare...
  5. M

    60/70 sheet metal

    Can anyone tell me if the center grill strip (thin piece with "oliver" on it) Is the same for a 60 and 70? Thanks
  6. M

    Frustrated with cub in So. Indiana

    Thanks to all those who gave suggestions. Took the carb off of my dad's cub and put it on mine. Runs like a sewing machine! So now know it is a carb problem. Soaked mine in a gallon jug of carb cleaner for about an hour, washed and blew it out. Now will idle without choke but air screw is only...
  7. M

    Frustrated in So. Indiana with cub

    IH- have changed out that jet several times in the last two days
  8. M

    Frustrated in So. Indiana with cub

    I will try again. Heck I can get this off now in about 30 seconds!!
  9. M

    Frustrated in So. Indiana with cub

    Checked and cleaned the screen, sure it is back correctly Thanks
  10. M

    Frustrated in So. Indiana with cub

    It is in
  11. M

    Frustrated in So. Indiana with cub

    Checked needle vavle and set float
  12. M

    Frustrated in So. Indiana with cub

    No
  13. M

    Frustrated in So. Indiana with cub

    I have an international loboy. Great little machine...but Will not idle. Here is what I have done. Cleaned carb several times, every oriface,every part, all of it, looks new. New points,condensor,cap, rotor,plugs,set timing. Checked fuel flow, it will run out gallons at full stream, no filter...
  14. M

    Carburetors

    Guys, will a Marvel tsx 159 (WD carb) fit on and work on a Allis "c" (tsx 154)? Are the jets different or just the manifold bolt pattern? Thanks
  15. A

    12.4-40 tire

    I need a good 12.4-40 rear tractor tire. Anyone have one for sale? 951 526-4103
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top