(800) 853-2651
SHOP NOW

Recent content by Mr.Ferguson

Yesterday's Tractor Forums
  1. M

    Bargain alert, NOT

    Must be one of them ? I know what I have, no low ball offers? deals. I?ve come across a lot of them.
  2. M

    Swing arm/Orchard Mower

    It all depends on the situation at hand, but here?s some thoughts: How does the Oliver handle the current mower? If it?s not working too hard with that one, you should be just fine. If it really has to work with that current mower, I wouldn?t go bigger. For the hydraulics, I would look around...
  3. M

    Historical question, NOT a flame...

    A-C did have some huge machines! I?m not sure where you got that information from, but in the 70?s they some pretty big stuff. The 8550 had a 844 cubic inch twin-turbo straight-six diesel coupled to a power shift transmission. If that?s not big for the time it came out, what surpasses it in...
  4. M

    How to start a 1940s TD8 International bulldozer

    TD tractors were a part of the IH Gas-to-Diesel machines. These used an electric starter to start the motor on gasoline, and once warmed up, the operator would open up there throttle , push the diesel lever forward, and the motor would switch to diesel. I can?t remember exactly what the...
  5. M

    John Deere 15 Flail chopper

    My grandpa has an old Deere 15 flail chopper. I got to thinking and remembered something about the the 16 flail choppers being made by New Holland. I was wondering if this was the case with the 15s. If they were built by New Holland, what model crosses over to the Deere machine? Mr.Ferguson
  6. M

    D14/15 power steering pump needed!!!!

    Oops. I guess someone already tried to contact me and I didn?t check my email. My bad. Well lesson learned, check your E-mail more often.
  7. M

    D14/15 power steering pump needed!!!!

    I need a power steering pump for my D14. If you have any idea on how to get one,email me. Mr. Ferguson
  8. M

    Allis-Chalmers D14/15 Pump needed!!

    Hmm, try again with this one.
  9. M

    Allis-Chalmers D14/15 Pump needed!!

    Thanks, shoot me an email with your number and I will have my grandpa cola you tomorrow. Thanks. Mr.Ferguson
  10. M

    Allis-Chalmers D14/15 Pump needed!!

    Hi there, It?s finally time for my D14 to run again. Some of you may remember my post on the D14?s very badly damaged power steering pump, and so I need one. Any and leads are welcome, but am in Washington and will have to arrange shipping. If you have one, E-mail me with more info. Thanks to...
  11. M

    2600 Injection pump leak?

    It depends on how adventurous you are. You can fix it yourself, as the issue is probably nothing huge. Doing it yourself can also save money, and gives the assurance that you knew everything you did to the pump, and you did it. But taking it to a shop is a good alternative if you don?t have...
  12. M

    Main Differences Between TO-20 and Ford 8N

    The Ferguson TO-20 has an over-head valve style motor, while 8n?s have a flat-head motor. Power wise they are about the same. I believe the rear axles are just a little different, and I don?t think they change over. They both have a 4 forwards and one reverse transmission with neutral...
  13. M

    power steering on wd45

    On the steering shaft, the orbital motor has 2 covers. The top one is a locking bolt, the bottom one is your adjustment. If you toy with these, it should help. As I recall, just adjust until it feels right. This could be caused by the introduction of air into the system, or something else to...
  14. M

    D 17 oil pressure

    The unofficial series 1 machines, 57-60 if I remember right, don?t have great quantities of oil pressure, and 12 psi is ok for running.
  15. M

    Potential Value Parting the MH44?

    I personally would find the source of low compression, and work from there. Parting it out can bring some cash, but I would check and find the issue first. Or maybe state in the ad it?s issues, and someone might find a nice project out of it.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top