-
M
JD 3010 CLUTCH
Thanks for the replies. I have the tool for adjusting the fingers. I am however going to take it apart and check the step height. I am unsure if this wes done or not- Mr New
- Post #6
- Forum: Tractor & Farm Talk
-
M
JD 3010 CLUTCH
I have a 3010 with the dual clutch. Maybe they are all like that? I had the flywheel turned, I replaced the pressure plate assy with the new friction disc. I installed the pressure plate assy to the flyheel, with the alignment tool. It seems like the friction disc for the pto is not clamped in...- Mr New
- Thread
- Replies: 5
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy