(800) 853-2651
SHOP NOW

Recent content by mrjata

Yesterday's Tractor Forums
  1. M

    4020 leans out when hot, vapor lock?

    Tried to start it tonight when it was cold, wouldn't run without the choke, wouldn't excelorate with the choke on, Drained all the fuel will blow out lines tomorrow and get known good fuel to replace. Fingers crossed. Oh moved the fuel line out away from the block about 1/2" too.
  2. M

    4020 leans out when hot, vapor lock?

    Haven't checked fuel pressure, but if it was low it wouldn't run much at all, even with the choke pulled. All things are pointing to percolation or vapor lock. Might get the lift pump to be safe, not expensive at all. But All states ag shows 2. wonder what the difference is?? One looks like...
  3. M

    4020 leans out when hot, vapor lock?

    Just plain pump gas, going to check a fuel sample today, maybe get the fuel line moved. Going to talk to a JD tech tomorrow
  4. M

    4020 leans out when hot, vapor lock?

    I am going to put a lift pump on and insulate the fuel line, both. This has happened before, same symptoms. And yes, once it was when the tank was on the last 1/4 of volume. This time it is 3/5 tank level but the pump can also restrict fuel flow just from gravity so it could be defeating the...
  5. M

    4020 leans out when hot, vapor lock?

    Got a 4020 gas, acting up a bit. When I have been running for an hour or so in the hay field at temp, it starts to lean out, so I tug a little on the choke, it runs fine, then after a while it almost dies, and I limp back to the house with the choke fully pulled. Already flushed the tank, carb...
  6. M

    Looking for a disk mower caddy

    Just ordered a Stoney Point today. No trailer here, think I am the only one without one. How well do they pull down the road with no disc mower on them? I have 2 hours home.
  7. M

    Looking for a disk mower caddy

    Thanks for the info, I will do more research. FYI I am clear up in the NW corner of Missouri, north of Kansas City about 2 hours.
  8. M

    Looking for a disk mower caddy

    I have been looking for a disc more caddy online and at a few local dealers with no luck at all. I would prefer used to save a little money. KMC is the brand of choice but I am open to suggestions. Close to NW Missouri would be a huge help. Love these forums!
  9. M

    farmhand f11 loader pump questions

    Thanks for all the replies. I just needed something that was easier detachable. I won't be using it all the time, maybe. What kind of price do you guys think I should ask for the loader? Can you see good enough in the pictures?
  10. M

    farmhand f11 loader pump questions

    I have a 3020 with a farmhand f11 POS loader on it with the pump on the 1000 rpm shaft on the belly. How do I get the stupid pump off the shaft? I cant find/see and cupler or pins to press out/off. All there is a is a chain, and a short lever to keep the pump from rotating. Putting a 148...
  11. M

    148 loader and 3020D

    I would love to plumb back into the reservoir like this picture. Not real fond of tapping into the line by the filter or into the filter canister. I am having problems finding these fittings, though. any help would be appreciated. thanks for the JD numbers on the feed line, not for the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top