(800) 853-2651
SHOP NOW

Recent content by mroman59

Yesterday's Tractor Forums
  1. M

    obsolete coil

    The ignition coil is mounted very close to the flywheel. The primary coil and charging coil are located under the flywheel. The points and condenser are located under the cam cover. The coil has laminated metal (I think that is what you are referring to) on each end and these ends have holes...
  2. M

    obsolete coil

    Yes, this outboard is a pull start and no electric/battery start option. It has a primary coil under the flywheel and there are magnets. It has a charging coil designed to charge a trolling battery and points & condenser. Its a 4 stroke engine. Tell me if I am missing any needed...
  3. M

    obsolete coil

    No I am not sure the coil is bad. I just heard of many people who said there motors ran fine and then when it died on full throttle, they found out it was the coil. Supposedly the coil heats up and then dies. I was just thinking this is my case. Some say the condenser can behave like that...
  4. M

    obsolete coil

    Hey guys, I have a 10 HP Honda outboard motor, 4 stroke with points & condenser, for which the coil is obsolete. As far as I know it is a 6 volt system because the coil says 6 volt on it. It was manufactured in 1978. The coil is a dual spark ignition coil and I was trying to match up coils...
  5. A

    OT...mobile home hubs

    My trailer that I haul my tractor on has mobile home wheels on it, tires are dry rotted to the point now that I'm going to have to replace all 4 before using it again, was told that this wheel is now outlawed in Alabama. I plan on replacing the mobile home hubs with a 6 lug hub that will take a...
  6. M

    Wiring schematic - Simplicity 6216

    I am replacing my old 16HP engine with a 26HP Briggs and Straton engine. I was wondering if anyone has a schematic drawing for the tractor. The wiring in the parts manual is not very good for that. It just shows the parts and not detailed enough for my purposes. The dealer does have one, but I...
  7. M

    hydrostatic transmission

    Is it possible to convert my Simplicity 6216 manual transmission into a hydrostatic transmission? I notice that the higher models in the 7000's come with hydrostatic trans and even electric deck lift. I like my tractor because of all the attachments I have and would not want to by them all...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top