(800) 853-2651
SHOP NOW

Recent content by MSFARMALL

Yesterday's Tractor Forums
  1. M

    Farmal Super c? Sitting for 20 years at least steps to

    Where in Mississippi are you located? Im in east central Mississippi and have an engine if yours is not repairable.
  2. M

    What good is the screen inside my new gas and diesel can

    Without a vent, its still going to glug, glug, glug. I have one with filter also and it probably takes 3 or more minutes holding the jug to empty it. I finally bought a little pump with 10 hose and it makes filling tanks a lot easier.
  3. M

    New to me Cub lo boy fast hitch

    Hey golf cart man, Im in Enterprise, MS. Its good to know I have a fellow YTer close by. We actually played Forest in football this year.
  4. M

    Farmall Blade

    I cant find any more pictures but it is basically a 2 x 2 tubing with 1/4 wall thickness rectangular frame with some cross bracing for strength. The blade is 1/2 plate that was formed by a local iron workshop. If you make one, make it as strong as you can because you will be surprised what you...
  5. M

    Farmall Blade

    The blade I built several years ago. It attaches to the rear final drives with bolts and the lift is attached to the right touch control arm. If the link to the touch control arm is rigid, instead of a chain, you will have down pressure on the blade which is very beneficial.
  6. M

    Farmall C, hewers of wood and drawers of water

    Did this tractor come from factory without Touch Control hydraulic unit?
  7. M

    Opinion on burned tractor?

    I had a similar situation with a Farmall 100 I bought. The back tires were burned almost completely off with only a small part of one front tire remaining. Paint was burnt and 10 gallons of gas boiled out of tank. I bought tractor home and hooked up battery using a jumper wire to distributor and...
  8. M

    Super A Snow Plow Extension Arm

    Ive found one online for 100$ but thats a little too expensive for me. I think I will just end up making one. I have printed the picture and can enlarge it on printer until I get the correct size. Thanks for the help!
  9. M

    Super A Snow Plow Extension Arm

    I attached a picture. The piece I need is the curved flat bar.
  10. M

    Super A Snow Plow Extension Arm

    Sorry for the poor description. This piece is attached to the right side touch control arm and is made out of approximately 2 flat bar that is curved downward to extend the reach of the lift arm. It has two holes that match the two pin holes of the touch control lift arm and an additional hole...
  11. M

    Super A Snow Plow Extension Arm

    I'm looking for the Touch Control extension arm for the Farmall Super A if anyone has a good source that won't cost an arm and a leg. Thanks in advance.
  12. M

    Farmall Super A Hydraulic Pump

    I have a rebuild kit ordered and will let you know how the two seals worked out.
  13. M

    Farmall Super A Hydraulic Pump

    The shaft measures .622 in the grooves worn by the seal but measures .625 in unworn areas. I put a new seal in but the new ones are very narrow as compared to the original seals. I think I have room to install two of the narrow seals so may try that before I go the speedi sleeve route. Thanks...
  14. M

    Farmall Super A Hydraulic Pump

    The hydraulic pump oil is leaking into the crankcase and shaft is worn so I will need to install a speedi sleeve. Does anyone have the part number for the correct speedi sleeve? Thanks in advance!
  15. M

    Farmall at the sale today

    It is a Super A. The Super A1, basically the first Farmall 100, had the taller radiator and the extra wide bar in the grill. This increase in radiator height also caused a gap in between the gas tank and the hydraulic unit which this tractor DOES NOT have so it is most definitely a Super A.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top