Recent content by mtf

  1. M

    Reddy heater pro 115 runs then shuts off

    One solution that no one has addressed yet. There is a gasket for the fuel cap that has a small opening stamped into it off center. Lots of times this small piece does not get punched out from the factory.
  2. M

    Can you post pics

    Trying on my samsung s24 , no go.
  3. M

    Can you post pics

    Tractor I looked at and didn't buy a year ago. From a tablet.
  4. M

    percent of posters actually are farming

    I farm full time, the only thing I have ever done. This coming year I will be my 29th crop year. I don't post a lot, but enjoy reading about everyone else's adventures.
  5. M

    Sun shade will not retract

    On my t5050 there is a button you have to push to retract it. It is on the left side of the shade, just a little pin.
  6. M

    Ford 7000 row crop fenders

    My neighbor here at the bottom of the bluegrass has a 5000 row crop he is parting out. He did have a set of good fenders on it, if he hasn't sold them. Search marketplace in Scottsville, KY.
  7. M

    Recurring injector pump problem

    The standing lubricaty formula is the better of the two. I use it along with atf at fill ups on non common fuel rail tractors.
  8. M

    New Holland 1411 hp

    A lot would depend on how hilly your ground is. Here at the bottom of the bluegrass, we have hills. Anything small than 80 PTO hp. And it will push you around too much, just not safe. On flat ground the 6610 could handle the mower, but I would not want to go any smaller. Be safe. Nathan
  9. M

    '81 Ford

    The fuel pump will leak fuel into the engine. I have had a time the last 3 years finding a fuel pump that will last for my 64 chvy c60 grain truck. I ordered the 4th one back in March, it was a Carter. So far so good. The others were a different story, 2 did not last 5 days each, before...
  10. M

    6415 Hood repair

    Do you know what he used to fix it?
  11. M

    6415 Hood repair

    I have this tractor and the hood has cracked in several spots. A replacement at $3800 is out of my budget now. My question is has anyone tried the PC plastic welding rods for zenoy to repair these hoods? What were your results? Thanks for any help.
  12. M

    What tractors did you drive as a kids?

    Super A, Ford 4000, Massey 165. The massey is long gone, and would not want it back. Still have the Ford and "little" A.
  13. M

    NH 570 age by s/n

    I don't know the answer to that. I did look up years of manufacturing and it listed 89-08. So mine might be an 89 instead of 88. Earlier ones like mine and yours have. Hard rubber gauge wheel. Basic jack. Metal PTO shield. I would guess they went to plastic PTO shield in the late 90's...
  14. M

    NH 570 age by s/n

    That looks very similar to mine, both have the metal pto shield. I think mine is an 88 model.
  15. M

    Help with new Holland hydraulic cylinder for discbine

    Drive the cylinder head back in, and there should be a retaining ring that keeps it from coming out.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top