-
Mudrig150 replied to the thread Mudrig's new Ford 3000.Got the gas tractor split. Was a bit of a process but got it done. -
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.It's a 65. I already got the coolant overflowing issue fixed with a new cap, the old cap only built 3 lbs of pressure, and the system...
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.Started stripping the parts tractor to get ready for the split. It'll clean up pretty good once I get the diesel on. Can the hydraulic...
-
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.Got the fuel outlet cleaned out, and yeah, it was totally clogged. Took an hour and a half to drain 3 gallons of fuel out of the fuel...
-
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.Changed the fuel filters on the diesel today, and yeah, I'll let the picture do the talking. Stand pipes were covered in rust as well...
-
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.Went ahead and did some testing today... engine still spins over so was able to verify the 3 point on the parts tractor works, as does...
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.Parts machine acquired! Kind of a shame to part out old 102550 but this one (34800 or whatever, I forget what the serial was) should be...
-
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.I found one that should work... later 8 speed gas 3000, terrible shape, blown motor.. I was hoping to get some spare engine parts but...
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.Well, the 3 point isn't really a top concern because a much bigger issue has presented itself. Went to pull the tractor out today, put...
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.I'm running it in position control. In draft control the 3 point won't lift at all. Not sure on the draft control plunger moving but it...
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.I've seen that before, but this doesn't seem like that. I went to drop the 3 point and the 3 point got halfway down and then it randomly...
-
-
Mudrig150 replied to the thread 8N carburetor leaks gas with shutoff valve open a 1/2 turn for starting and tractor won’t start. Any suggestions??.More than likely your float is sunk or the needle valve has some junk keeping it from fully seating.
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.Ran for about 25 minutes today and the 3 point is acting up bad. Lifts and lowers like the lever is constantly being moved. The stud...
-
Mudrig150 replied to the thread Mudrig's new Ford 3000.3000 definitely is a fixer upper, that's for sure. After the previous post I made where I mowed around the scrap pile, the tractor...
-
-
Mudrig150 replied to the thread Early 3000 serial number weirdness.I wouldn't be surprised if it was a pre-production tractor. It's got some weirdness all around and a lot of workmaster parts on it...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy