(800) 853-2651
SHOP NOW

Recent content by nc super c 1

Yesterday's Tractor Forums
  1. N

    farmall h

    If you want it done right the boster has to come off.mine was so mess up and lock-up I removed it completely.my crank had a coupler bolted to it then end to what you have broken was trimed and pinned with a 1/4"gr.8 bolt.then the coupler was knotted to slide around the harden bolt.looks tacky...
  2. N

    some quick work on the H

    dont touch the reg.as of yet being 12v may need a extra wire and switch to show charging cond.it needs to be exicted as you would a alt.I am not near my H were I can tell you the right I can you this one hooks from extra switch to amp gage.if its mag. ign.if not can be hooked to batt. ign.switch...
  3. N

    super c with hicups

    have a super c that hicups while the lift is in raised position touchcontrol has hy-trans in it and is full.the control value on side of touchcontrol leaks some have replaced the seal in the top what could be the problem? john
  4. N

    tires inflated with ether

    thats what tire cages are for I have seen first hand 22in tires with split rims let go and took out 4ftx4ft cement block wall what a noise.
  5. N

    to 35 gas in oil?

    another possiblety could be fuel tank shutoff was left open have had that to happened before.on my to30. john
  6. N

    sediment bowl repack?

    I use same cotton string used in chalk and on chalk lines. good also for most threaded plugs or fittings as well. John
  7. N

    need old tractor umbrella frame.

    Lots of luck I to am searching for one for my TO30 the C was to tilt the umb. left,right,front&back to allow for more shade from the sun I have one from our old B farmall canves rotted away. IS OMAR THE TENT MAKER STILL IN BUSSINESS.YOU RECKON? John
  8. N

    Farmall Rim Paint

    case ih dealers carry what you are looking for in either container rattle can or qts .qt.will do all 4 rims priced right looks right john.
  9. N

    M 602 gas picture Mt Vernon ohio

    talking about a load not reality in 1965 i worked for a man and his son mm dealers had a new m602,g,5star,&ub all had 4-16 except ub which had 3-16 the 3 4plow tractors were in the 40-52 hp class.last count the 5 star,and 602 are still in use.that was this past oct.one of best around.but time...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top