Recent content by Nickc711

  1. N

    New Super A clutch Problem

    The clutch Friction plate is installed flat side towards the engine. All the fingers were the same height There is approx 1 in of freeplay in the pedal I tried using less but that didnt help I did replace the pilot bearing(greased) as well as the release bearing. I think the pilot bearing...
  2. N

    New Super A clutch Problem

    I recently replaced the clutch friction plate and the pressure plate. But the clutch does not fully disengage. Should I adjust the pressure plate. My pedal throw is good? I thought the pressure plates came pre adjusted? Thanks
  3. N

    Super A piston ring help..

    This message is a reply to an archived post by Bob on April 13, 2011 at 23:39:10. The original subject was "Re: Super A piston ring help..". These rings are junk!!
  4. N

    Steeped head pistons

    I recently ordered an engine kit for my super a with steeped head pistons thinking thats what i had because they were raised in the middle but what i got is huge compared to what i had, are these the same, do i need to modify my engine to support them? thanks
  5. N

    Super A crankshaft

    I am sending my crank to the machine shop to get re-ground, what info/parts do i need to give them, i got the i-t manual but im unclear if the measurement in the front of the manual is the minimum diameter or the actual diameter
  6. N

    Which manual?

    Im about to undergo a engine rebuild on my super a, which manual would be better the IH engine manual or ITs repair manual?
  7. N

    Water in the oil Super A

    Antifreeze, i couldnt tell what was in the oil, couldnt tell if it was rusty water or green rusty water you kno where i could find the torque specs?
  8. N

    Water in the oil Super A

    I just came back from moths of being away to go to change the oil in our super A, upon draining i found masses of water in the oil i would say at least a half of gallon, it seemed recent because nothing was rusty, I took the head off the head gasket seemed ok, I just dont kno if its the block or...
  9. N

    Hard Starting

    I found the drain problem by intuition. The light switch is not correct and has an extra position,basically two off positions..and one is the drain position!....I think the starter is bad now when i try to turn it over it just sparks at the positive terminal and does not even attempt to...
  10. N

    Hard Starting

    First off I just rewired the tractor and just got the battery tested.(6v super a) The tractor has some electical issues still. Even when the battery is full sometings it will be very hard starting other times it will be fine. Yet other times when it sits it will drain the battery. And when it is...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top