(800) 853-2651
SHOP NOW

Recent content by NickGF

Yesterday's Tractor Forums
  1. N

    MF35 - 4cyl deisel loss of power problems

    This message is a reply to an archived post by Nickgf on February 02, 2012 at 14:51:06. The original subject was "Re: MF35 4cyl deisel loss of power problems". I did a spill test after marking the bottom pully at 16 degrees before TDC and fixing a pointer to the chassis on the mark so I could...
  2. N

    MF35 - 4cyl deisel loss of power problems

    Hi Evan ... That's exactly what I thought regarding the injection pump. I did the rebuild using a CD I bought from England on the MF35 rebuild, the detail was good and I tried to follow it exactly, but I guess it's possible that I slipped up and something could be out. I would have thought that...
  3. N

    MF35 - 4cyl deisel loss of power problems

    Hi Evan ...thanks again for your quick response. I removed the fuel tap and glass bowl, the flow from the tank was fast and clean. I cleaned the bowl and mesh filter just to be sure and blew through the openings to make sure there was no internal blockage. After reasemling I removed the injector...
  4. N

    MF35 - 4cyl deisel loss of power problems

    Hi Evan ... Thanks for your help (I'm South East of Melb)The engine can miss a bit when first started and I had put this down to the injectors not being up to scratch (as I did not renew them with the rebuild)but I am only guessing. I did some slashing this morning and took note of what the...
  5. N

    MF35 - 4cyl deisel loss of power problems

    Hi ... head was retorqued short time after rebuild running.
  6. N

    MF35 - 4cyl deisel loss of power problems

    Hi ... I did a complete overhaul of my MF35 - 4cyl diesel engine and everything went ok. The engine starts ok with a small squirt of aero start. It seems to run ok and I bedded in the rings doing some grader and general farm work for a few months. Everything seemed ok until I started to do some...
  7. N

    Removing Main drive assembly

    Thanks...much appreciated Nick
  8. N

    Removing Main drive assembly

    Can you tell me if this same procedure applies to a MF35/4 cylinder deisel with a 2 stage clutch because I have been having the same problem trying to access the transmission seals which I would like to replace while I have got my tractor split. Thanks ... Nick
  9. N

    MF35/4cyl diesel - front transmission seal

    Thanks Don, your help and advice is appreciated.
  10. N

    MF35/4cyl diesel - front transmission seal

    I'm trying to replace the front transmission input shaft seal on MF35 with 2 stage clutch...but I'm having no luck removing the casting that I believe holds the seal. It comes away from the bell housing about a 1/4 inch and then seem to be stuck on the (outer) larger of the 2 splined drive...
  11. N

    MF35 4 cyl diesel clutch thrust bearing

    I have just split my MF35 4 cyl diesel to do a comlpete engine overhaul. While it is slit I was wondering if I should replace the clutch thrust bearing. Can someone tell me is there a test to tell if it needs replacing, or is it recommended to do it anyway while the tractor is slit. Some advice...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top