(800) 853-2651
SHOP NOW

Recent content by Norwichjc

Yesterday's Tractor Forums
  1. N

    Old Olies Info

    Please add me to the list. Have 1850 w Perkins diesel. Thank you
  2. N

    Oliver 1850 steering box problem

    Good mornin. Do you have parts descriptions for the image you sent me?
  3. N

    Oliver 1850 steering box problem

    Good evening. I'm in process of rebuilding the pedestal. You were kind enough previously to send a diagram with numbers for each part. Do you have the corresponding itemization describing each part?
  4. N

    Oliver 1850 steering box problem

    Update: my problem is the bearings in the narrow front pedestal. There is quite a bit of play in the shaft. I have the pedestal off the tractor but having reat difficulty getting the 2 3/8 nut off the spindle. Anyone have any tricks? I've tried heat, solvents, etc. The metal of the nut isn't...
  5. N

    Oliver 1850 steering box problem

    John eight60/ three34-898nine
  6. N

    Oliver 1850 steering box problem

    Would it be OK to call me. I can text some pics. The steering box itself is only held in place by the 1 1/8 bolt that screws into the shaft. That metal bar retaining shaft is affixed to frame with 1 bolt. The other side is just a hole that a pin on the steering box slides into. Are you saying...
  7. N

    Oliver 1850 steering box problem

    There is only 1 bolt on the bar and it is tight. Somehow the spindle itself, bolted inside the steering box, is moving up and down causing the steering box to raise high enough where the retaining pin on the box comes out of the hole on retaining bar. The bolt holding the box on the shaft is as...
  8. N

    Oliver 1850 steering box problem

    There is definitely play in the spindle
  9. N

    Oliver 1850 steering box problem

    There is definitely in the spindle
  10. N

    Oliver 1850 steering box problem

    That bar with the hole at the end that a 1/2 inchish pin/peg, part of the steering box, is there. My problem is the whole steering boxassembly lifts out of that during ooeration
  11. N

    Oliver 1850 steering box problem

    There was no brace bar in there when I took it out the first time. Another source told me it could be a bearing in the narrow front pedestal that's supposed to hold that shaft in place. Does that seem a possibility?
  12. N

    Oliver 1850 steering box problem

    The flat bar goes over the steering box to prevent it from lifting out of place?
  13. N

    Oliver 1850 steering box problem

    Good morning. I have an oliver 1850 with marrow front end. The steering box located under the radiator jumps out of position, mangling hydraulic lines and disabling steering. The box is held in place by a 1 1/8 bolt that screws into steering shaft and a pin that slides into a hole. I assumed my...
  14. N

    Best older farm tractor?

    So true
  15. N

    Best older farm tractor?

    Good advice. Thank you
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top