(800) 853-2651
SHOP NOW

Recent content by nydolphin

Yesterday's Tractor Forums
  1. D

    snowblower engine....goofed up the magnets

    All, I tried to pry off the flywheel of a horizontal 8 hp (supposedly) tecumseh from the late 1980"s snowthrower engine due to weak spark. Fast forward, I got the fywheel off, but managed to crack free 3 of the six magnets off the inner part of the flywheel. What kind of glue do they...
  2. N

    fuel leak on M

    I hope, after all this, the new sediment bowl ISN'T junk. It's numbered 370832R91 and says it replaces IH 358245R91...
  3. N

    fuel leak on M

    Thanks Rusty. I bought the 'everything' kit because it was only $7 more and I figured maybe I should be a little more thorough. Now if the rain would just stop... Thanks again to all. I'll let you know how it goes.
  4. N

    fuel leak on M

    I did take the carb apart, as suggested, checked the float. The needle appeared to be seating properly but when I put the carb back together it continued to drip. It is overflowing and it doesn't help that the shutoff isn't working. Must be the needle... Ok. I just got back from the local store...
  5. N

    fuel leak on M

    Went right out this morning. What is the number on the upper half of the carb (throttle body?) number is 8557D. I was looking at rebuild kits in the parts section and noticed there are quite a few different ones.
  6. N

    fuel leak on M

    I have decided, after taking the sediment bowl apart, that yes I should replace the entire thing. This will solve the gas getting TO the carb. I assume Rusty that you mean the horizontal adjustment screw, directly off the front of the carb, as the needle seat? This has a felt gasket around the...
  7. N

    fuel leak on M

    It is leaking directly from the very bottom opening of the carb. I'm assuming that is an overflow because when I choke it to start this is where it blows off the extra fuel.
  8. N

    fuel leak on M

    I have tried most everything I can think of, short of rebuilding the carb. Removed and cleaned the fuel bowl, checked the float to make sure it is seated. The carb is still leaking out of the bottom, drip by drip. Even with the fuel shut off it will empty the tank in a few days. Not a full one...
  9. N

    ordering from ytmag

    Can I feel confident ordering from this site, in the parts section? I am in need of seat parts and miscellaneous stuff for my M and am finding the prices relatively close to others. Anyone had trouble?
  10. N

    '51 M Seat

    That looks like the one Rootsy, thanks. I like your idea Rusty of just replacing the bolt and bushings. It's a work tractor not a show. Thanks
  11. N

    Siginaw 3 points and drawbars

    I have a Saginaw and an M and was told I could use both. When I put the Saginaw on I removed the drawbar, so all I can go on is what he said. Call him. He was great to do business with.
  12. N

    '51 M Seat

    Anyone know what IH calls the seat pivot point, with bolt and rubber bushings, for the seat? Just below where the seat 'shock' is attached. I find no reference to it in the parts section here and locals haven't been able to help me. I've had no problem finding the shock, spring, etc. Mine...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top