(800) 853-2651
SHOP NOW

Recent content by Oak

  1. O

    looking for this 1939 Farmall h

    Looking for this 1939 Farmall H i built may years ago and sold last heard it was in NY state If you see it let me know please Ph# 419-707-0676 Thanks in advance
  2. O

    JD 410 Backhoe hydraulic Flow chart needed or service manual

    Thanks will see if it helps but if anyone has manual i would like to get one thanks again
  3. O

    JD 410 Backhoe hydraulic Flow chart needed or service manual

    Anyone have old manual that the would like to sell or maybe send picture of Hydraulic flow chart may be help full Thanks in adavnce
  4. O

    looking for 684 IH sheet metal

    Hello I am looking for IH 684 sheet metal it has 3 hole front bolster. We have good hood but need complete nose and front lower side panels and battery cover, does any one have idea where to find these? I called local salvage yards but no help there. thought i would try this Thank You in advance
  5. O

    5020 with 24 alternator wire diagram needed

    Hello I am working on a 5020 that has wiring disconnected and is not charging and would like to get wiring diagram of how its to be My manual does not have the wiring diagram in it for the 24 volt alternator. any help would be great
  6. O

    2020 hard starting

    Hello I am working on a 2020 Gas that starts hard throttle has to be closed to start anything off of closed it will not start (choke does not help). when it does start it runs great Idles great high speed great. I have had carb off cleaned it and installed new fuel valve but no change any...
  7. O

    2 disc clutch who makes a good one?

    Hello I have never had anything do do with 2 disc clutchs and would like a little advise on who makes a good clutch. It is going in a ford with 8 bolt Crank. also may be interested in a good used clutch Thanks in advance
  8. O

    Info an TB120 injection pump timing needed

    Hello I am looking for information on how to time injection pump and TB120 Tractor it has a delphi pump Thanks in advance
    • Oak
    • Thread
    • Replies: 0
    • Forum: Ford
  9. O

    Replacing a pushrod tube ?

    Can a pushrod tube be replaced on a B head without removing the head?
  10. O

    Vinton Needle and seat for John deere B wanted

    all that I found avail are steel needle and brass seat roberts had a OH Kit listed with vinton needle but there ad was wrong and had steel needle. Thanks
  11. O

    Vinton Needle and seat for John deere B wanted

    For the Carb That Is Thanks
  12. O

    Vinton Needle and seat for John deere B wanted

    I and looking for the vinton style needle for a John deere b anyone know where they can be had? Thanks in advance
  13. O

    456 emissionised -Turbo Piston Differance

    Hello anyone know what the differance would be between the emission engine piston non turbo engine and a non emissioned Turbo engine piston in the 456 ford They are rated at the same comp ratio. ?
    • Oak
    • Thread
    • Replies: 1
    • Forum: Ford
  14. O

    Restored 40T Value

    Hello I have been asked by a friends widow to help here sell her husbands 40T It was just repainted prior (Pro job)to Him passing away He was the second owner of the tractor and is all original. Would anyone like to voice there opinion as to what she should ask for this tractor? I would like to...
  15. O

    8700 cab headliner plastic parts needed

    already tried them with no luck
    • Oak
    • Post #1
    • Forum: Ford
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top