(800) 853-2651
SHOP NOW

Recent content by old barney

Yesterday's Tractor Forums
  1. O

    hydraulic hose protection?

    thanks Im 73 years old hope I live long enough to finish it. living in Social security is tight also.
  2. O

    hydraulic hose protection?

    thanks looks like easy to install too.
  3. O

    hydraulic hose protection?

    I'm thinking of cleaning the lines of surface rust and using POR15 to cover the lines then painting over with Case yellow. I guess you would call this a project I'm not sure if it is going to be a total antique show tractor but I do want is close to restored as possible. I repair and don't like...
  4. O

    hydraulic hose protection?

    I'm replacing them all before I go too far. So far all 8 for the steering system from steering motor to cylinders. and the 4 to raise the front bucket. They were the first to blow. The large return from bucket control spool is too long and the steel section was worn through. The whole tractor...
  5. O

    hydraulic hose protection?

    Finally three weeks ago after starter rebuild it fired off with birds nest flying from radiator shroud, wasps flying at me, every thing leaking, And finally smoothing out and running. Yes it is a project.
  6. O

    hydraulic hose protection?

    I have been gifted a 1973 Case 489 B Ck, The flex hoses are ROTTEN, The Florida sun has ruined the outer jacket then the wire rusted and the hose blew up. I am replacing all of these. Is there any coating or covering that would preserve the new hoses? I have already replaced power steering...
  7. O

    Case 480 B Ck shuttle shift reverse

    My 1973 manual clutch shuttle shift won't go into reverse. Works in forward ok. This an 8 speed unit. I'm hoping some one will point me in the correct direction as where the reverse idler gear is? Can it be accessed through the big cover over the front area and the bolt that holds the shaft...
  8. O

    Case 480B Clutch Problem

    [ My 480B CK had a froze clutch I found the clevis eye holes wallered out on the ends of both clutch rods one at top of the first rod and at the adjustment clevis last rod on the bell housing rod. I replaced both clevis and adjusted it up so the clutch would disengage. But my tractor sat a few...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top