Recent content by oldguyandson

  1. O

    AC CA Points

    Am I measuring the current across the + and - on the coil? Thanks. I don't seem to be reading anything there with a my handheld voltmeter set on the 10A measuring mode.
  2. O

    AC CA Points

    Thanks.
  3. O

    AC CA Points

    I will check this and thank you for the suggestions.
  4. O

    AC CA Points

    Thank you.
  5. O

    AC CA Points

    I am having CA points issues. Recently did a 12v conversion w/rewire. All new tune up parts with new 12v coil. I've been unable to get it running smoothly. My points kept needing adjustment after it would not start at all. I'd open up the dist and the points would be closed without the...
  6. O

    AC CA Air Filter

    I cleaned out my air filter on my AC CA and filled to line with oil. When it runs the oil sprays a bit out of the top of the cup where it seats. I am curious if there is supposed to be a gasket around the top of the cup? Or maybe I need to bend my keeper tabs some to pull it tighter. Thanks.
  7. O

    AC CA Wiring

    UPDATE: Everything is working great now. Thank you all for your guidance and support!
  8. O

    AC CA Wiring

    I have a non directional indicator lamp I can put in line with the wire #1 pictured. Would this work? I have shown some pictures below. Bottom side of push-pull switch is #1 from alternator red, from coil blk, and voltmeter. Top side of switch is one to alternator post and the other to battery...
  9. O

    AC CA Wiring

    Thank you.
  10. O

    AC CA Wiring

    Thanks. The alternator is a Delco Remy with a label on it that says P7127M-3. The charging system on this tractor has never worked in charging the battery since I have owned it. I do not think it was ever working the way the PO had it set up. Correct on the voltmeter. I was trying to keep the...
  11. O

    AC CA Wiring

    So maybe I do have a three wire alternator. It has the 1 and 2 post under a cap. They were not previously used when I got the tractor. That setup never charged the battery. I pulled the hole insulators out of the old ammeter that was in there and used them in the voltmeter so I believe they...
  12. O

    AC CA Rewire

    I posted the in the AC forum but then it occurred to me that these are general questions so posting here as well. I am rewiring a 12v system with a one wire 10Si alternator with the 1 and 2 pin posts. I am trying to determine what gauge wire to use from the number 1 pin post back to the...
  13. O

    AC CA Wiring

    Hello. I am rewiring a 12v system with a one wire 10Si alternator with the 1 and 2 pin posts. I am trying to determine what gauge wire to use from the number 1 pin post back to the voltmeter. I am also curious what gauge wire to run from the coil back to on/off switch. I bought a new...
  14. O

    1945 2N Sherman Trans

    Thank you. I pulled the cover and one of the forks/rails does not move and the other fork is completely loose on the rail which must be the one that pulled out. See attached video. I hope it loaded. Are the bolts keeping the forks from sliding on the rail freely? If so I may need to take that...
  15. O

    1945 2N Sherman Trans

    *weep
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top