(800) 853-2651
SHOP NOW

Recent content by Paul J.

Yesterday's Tractor Forums
  1. P

    IH 16 FH Chopper and Three Heads On Auction

    It is next Monday, April 10, 2017, here's a link, http://www.faheysales.com/event/hobby-farm-moving-auction-new-prague-mn/ If you go to proxibid, there appears to be 2 base units plus the hay heads, we had one in the 70's that we used to green chop for the cows in early fall, but we hired a...
  2. P

    f 12

    There's a set on Craigslist in La Crosse WI for $300. Farmall F-12, F-14 Tractor Fenders http://lacrosse.craigslist.org/grd/6071644366.html
  3. P

    Heisler Overdrive manuals f-12/14

    If you have parts info/#'s that would be great if you could send them to me. As far as model, this one that I have cracked open I believe is for a F-14, it has 14/18 tooth output vs 16/20 tooth output for a F-12, at least that is what I have been told, and it matches up to the input shaft...
  4. P

    F-12 fuel system part

    I have a 37 F-12 donor tractor with this fuel system part, it was originally a distillate model. It appears that the fuel pump feeds this part and there is one smaller line that goes to the carburetor and a larger line that goes to a T in the supply line running to the fuel pump. I have parts...
  5. P

    Heisler Overdrive manuals f-12/14

    I appreciate the offer, but I should have been more clear in my original post. I have a copy of the installation instructions. I took this unit off a donor tractor and found the oil seals were leaking and the bearings were loose so it looks like it is going to need new bearings and oil seals...
  6. P

    Heisler Overdrive manuals f-12/14

    Does anyone have or know where I can get a copy of a owners manual and a parts schematic/parts book for a Heisler Overdrive for a F-12 or an F-14?
  7. P

    IH 444 Coil

    I am not able to get the tractor to start and I suspect I have a coil issue. I checked my books for specs and cannot find any. I have a couple of questions; 1 - What is the primary ohm reading supposed to be? 2 - what is the secondary ohm reading supposed to be? 3 - Is this supposed to...
  8. P

    444 - 3 point problem, won't lower

    I have a new problem that started when I went to lift my bush hog, (which is fairly heavy), and is still happening with the back blade attached. When I lift the 3 point it will not go back down with the tractor running. Power steering and loader work fine. Also, when I start the tractor the 3...
  9. P

    444 Hydraulics quit

    Thanks for the suggestions, I was able to get it going; changed filter under the steering column(real dirty), cleaned the screen in the reservoir(a little dirty), and cleaned the little screen under the seat(not much there for dirt). Still nothing, then I tried tapping on the relief valve on...
  10. P

    444 Hydraulics quit

    I bought a IH 444 gas last fall with a Westendorf loader. According to the serial number, I think it is a 1970 model. It had been sitting in a barn for 10 or 15 years with minimal use prior to my purchase. We changed all of the fluids, but did not drain the loader cylinders, and we did...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top